MLC
6Pages

High Visibility, Even in Sunlight The ultrabright LED indicator, featuring high-power LED and IP65 compliance, is now available. IP65 compliant RoHS Directive compliant A ultrabright LED type, which provides clear visibility even in sunlight: TYP.7000cd/m2 (reference value) Excellent visibility thanks to red, green, and yellow LED colors and diamond-cut cover Providing high visibility by introducing the ultrabright LED and diamond cut cover; expanding uses such as warning indicators The IP65 compliant type (providing protection from water flows) withstands both rain and dust (this applies to the front only when the panel is attached) Easy φ25 hole screwing and the flat and dorm shapes available with the 30 square and 30 round types Shade hood and terminal cover (for screw terminals) available as accessories Sunmulon Co.,Ltd.

RATING Current rating (mA) Insulation resistance 100MΩ or greater with a DC 500V Megger Dielectric strength Between terminals and ground: AC1500VRMS, 50/60Hz for 60 sec. at normal temperature and humidity Ambient humidity Reverse dielectric strength 150V Ambient temperature * For externally attached LED resistors, see the last page. Square flat type Sunmulon mark side Square dome type Sunmulon mark side Round flat type Sunmulon mark side φ30 Sunmulon mark side Round dome type note that height of the MLC type is different from the one of the current ML indicator.

Thickness of the board which can be used for mounting Sunmulon mark side Sunmulon mark side Note: To install together, please set apart from each other by at least 50mm from the panel cut center line for heat radiation. Screw terminal Mono-color illumination /Lighting Accessories Shade hood Terminal cover PART No. * A piece of rubber packing is set inside. Installing the terminal cover Installing the shade hood (square and round) * With water resistant structure (Otherwise rubber packing is not required) *Only screw terminals can be used Sunmulon mark side Square hole portion When the...

MLC Precautionary Notes for Handling 1. The MLC super hi-bright type is created based on the current ML indicator. However, please confirm the following points: 1) The filter and cover of the current ML type can be used for the MLC type. Likewise, the diamond cut cover and shade hood of the MLC type can be used for the current ML type. The terminal cover can also be attached to the current ML model and the AC/DC 100V unit, so please purchase it as a replacement part. 2) The AC/DC 100V unit of the current ML type cannot be used for the MLC type. 3) The MLC type is available as an integrated...

Shapes and Illumination Methods S0 Square flat Square dome Mono-color illumination Round flat Mono-color illumination Mono-color illumination M0 Round dome Mono-color illumination Cover Colors DC Clear (diamond cut) X Terminal Shapes Black Gray Fastening screw #187 tab/solder No terminal Operating Voltage 2 12V with a built-in resistor 3 24V with a built-in resistor 5 12V without a resistor 6 24V without a resistor Notes *1) Only the diamond cut shape is available for the cover of the MLC indicator. *2) See the PDF document for externally installed LED resistors. *3) In case of No cover...

MLC Externally Installed Resistor Data See the table below for externally installed LED resistors Diode voltage in regular direction Voltage in regular direction VF (V) (reference value) *1) Recommended operating current I F (mA) Conditions at the time of pulse lightening *2 Current decrease rate of LED (mA/ ºC) (between t1 ºC and t2 ºC) (Reference value) Max. pulse allowable voltage in regular direction 1FP (mA) *1 Recommended operating current 1F (mA) *2 Current decrease rate of LED (mA/ ºC) (between t1 ºC and t2 ºC) (Reference value) Wiring figure *1) The recommended operating current...