Multi Roller Type Superoll CSA Selection Chart Workpiece size 03 - 07 * Tool Length G and Overall Length L varies between the range in the table below by adjusting the tool diameter. TooL modeL Tool d ia mete r adjustment range A TooL diameter adjustment range A Burnis hing Length H is available up to Overall Length L Burnishing is ava iLa bLe up to OveraU Length L is avaiLabLe up to OveraLL Length L Specifying Tool model About tool selections Non-burnishing length Burnishing conditions [Reference) E.g.: CSA300AShank model (either A, B, F, C or D)* Refer to below table for Shank model. — Tool model No. = Workpiece size x 100 * The □ at the end of Tool model is a letter of the alphabet (either A,B, F, C or D). The alphabet varies depending on Shank model. * Shanks other than those listed below are also available, however the Burnishing length H may be limited depending on the requested shank specifications. Workpiece size Workpiece size Rotation speed *Non-burnishing Length above keeps a cLearance 0.5mm between SuperoLL and a workpiece bottom surface. * To minimize non-burnishing Length for SuperoLLburnishing, grind off Head protruded Length from RoLLer tip to the same position as RoLLer tip after setting a tooL diameter. * Burnishing conditions are reference onLy, and do not guarantee that they wiLL achieve the customers' required vaLues. * ActuaL burnishing conditions vary depending on the materiaL and conditions before burnishing, so these vaLues shouLd be used as a reference. © 2 02 3 SUGINO MACHINE LIMITED www.sugino.com IncLuded detaiLs are current as of May 2023. Unauthorized copying or reprinting is prohibited.

Multi Roller Type Superoll CSA Selection Chart Workpiece size 011.1 - 014.9 Specifying Tool model Burnishing conditions (Reference) * Tool Length G and Overall Length L varies between the range in the table below by adjusting the tool diameter. Tool diameter adjustment range A Throug h hole diameter K Shank model (either C or Dl * Refer to below table for Shank model. I— Tool model No. = Workpiece size x 100 Shank model * Burnishing conditions are reference only, and do not guarantee that they will, achieve the customers' required values.* Actual burnishing conditions vary depending on thematerial...

Multi Roller Type Superoll SA Selection Chart Dimensional Drawing Imm) Workpiece size 015 - 024 Workpiece size 045 - 064 RoUer Burnishing Length H Adjust ring Workpiece size 025 - 044 Tool model Tool diameter adjustment range A Tool model Specifying Tool modelSA OOOOI— Tool model No. = Workpiece size x 100About tool selections* Shank is also available for shanks other than Morse tapered shanks.* Sizes other than the sizes listed in the selection chart are also available. Please contact your nearest sales office by using the catalog inquiry sheet, or use the inquiry form on the homepage. About...