Fact Sheet High Flow Z* Depth Cartridge Filter Manufactured with Z.Plex* Technology Typical Applications Well injection Produced water filtration Water flood / enhanced oil recovery Amine filtration Seawater filtration General Properties Figure 1: High Flow Z filter (above) Inset picture: handle for change-outs High Flow Z Filters are available with four pore size ratings. They are made of 100% polypropylene construction. Tables 1 and 2 show further details on dimensions, and flow rates of the High Flow Z. Table 1: Dimensions Description and Use High Flow Z* is manufactured using patented Z.Plex filter technology and is engineered for RO prefiltration, well injection, produced water disposal and other applications. High Flow Z’s proprietary filter matrix provides unmatched performance in these applications. Low pressure drop Excellent dirt holding capacity Graded density decreases blinding Excellent temperature / oil resistance Provides lower total cost of filtration operations Nominal Outside Diameter Nominal Inside Diameter Table 2: High Flow Z psid vs. Flow Rate Find a contact near you by visiting www.gewater.com and clicking on “Contact Us”. * Trademark of General Electric Company; may be registered in one or more countries. ©2014, General Electric Company. All rights reserved. FSfilHighFlowZ_EN Jan-14

Table 3: Operating Conditions Ordering Information Maximum Operating Temperature Recommended Flow (in water) Additional Information Maximum Differential Pressure High Flow Z cartridge filters are made from thermally bonded fibers of polypropylene. GE filter cartridges are designed and manufactured for resistance to a wide range of chemical solutions. Conditions will vary with each application and users should carefully verify chemical compatibility. Please contact your GE representative for more information. Micron Ratings, Lengths and End Adapters Micron ratings: o Nominal Rated – 1 and 5 micron...