Sturtevant Richmont Global Reach. Local Support. Sturtevant Richmont Div. of Ryeson Corp. 3203 N. Wolf Road Franklin Park, IL 60131 Phones: 847/455-8677 800/877-1347 Fax: 847/455-0347 E-mail: [email protected] Web: www.srtorque.com Instruction Sheet ExacTorq Torque Limiting Screwdrivers - All Models Cautions • Always wear appropriate personal safety equipment when working with hand tools. • Use this tool only for the purpose for which it was designed. • Do not use this or any other torque tool in excess of its rated capacity. • Insure the bit is fully seated in the screwdriver and properly engages the fastener before applying force. ExacTorq Screwdrivers These tools are designed and manufactured to meet or exceed the requirements of ASME B107.14M and ISO 6789. ExacTorq limits torque in both the clockwise and counter-clockwise directions. See figure below for component nomenclature and use as reference for torque setting instructions. Torque Setting Procedure 1. Grasp the Handle and retract the Lock Pin. The Lock Pin may be held back or moved to the Locked Open Position. Do not attempt to rotate the Knob without first disengaging the Lock Pin by retracting it to the Open or Locked Open Position. 2. With the other hand, rotate the Knob until the desired torque (largest graduation on Major Scale past Thimble Edge + digit aligned with Arrow on Minor Scale) is attained. Rotate Knob clockwise to increase torque, counter-clockwise to decrease torque. 3. To lock torque setting, allow Lock Pin to return to Locked Position. 4. The torque setting may only be locked in for whole digit increments. It cannot be locked between digits. Bits, Extensions and Adapters Use only 1/4” hex shank, in-line bits, extensions or adapters with your ExacTorq. The bits, extensions and adapters should not exceed six inches in length.

ExacTorq Operation Grasp ExacTorq handle and insert bit into/onto fastener, making sure the fastener drive is fully engaged. Align the axis of the ExacTorq with the axis of the fastener. Rotate the ExacTorq steadily in the direction of tightening until the tool clicks. Further rotation will not increase the applied torque. Care & Cleaning When the screwdriver will not be used for a period of time, it should be stored at the lowest torque setting. The screwdriver should be cleaned only with a clean damp cloth. Calibration Instructions Required Equipment • Hex key (0.50”) for Thimble set screw...