Only I centring robot required Advantages for Front-of-Line: • No centring tooling required for single workpieces • No need for a centring robot including tooling and tooling change device • Less programming required • Reduced space requirements • Increased availability Advantages for End-of-Line: • Workpiece rotation of individual pieces by FeederPlus6neo • Reduction of the required robots in the EOL possible • Tooling requirement reduced by up to three toolings per workpiece • Reduction of make-ready time Convenient optimisation software StroCon PL • Increased output through optimised • Inspection of new tooldesigns movements • Calculation basis for determining the • Optimised curves available directly in the output control system YOUR SPECIALIST FOR AUTOMATION SOLUTIONS Strothmann Maschines & Handling GmbH Altenkamp 11 33758 SchloB Holte-Stukenbrock Germany Phone: +49 (0) 5207 / 9 122-0 [email protected] A member of the Siempelkamp group. STROTHMANN Machines & Handling www.strothmann.com Information about quality and application of products does not constitute a guarantee of properties, it is only intended for information purposes. The decisive factor for the scope of our delivery is the respective contract portfolio FeederPlus6neo STROTHMANN Machines & Handling

The FeederPlus6neo is an innovative feeder for linking press lines. It can bridge press centre gaps of 5.200 - 12.000 mm and is therefore suitable both for new press lines and for the modernisation of existing lines. The new feeder is an evolutionary step based on the tried and tested FeederPlus6, which is already being used with great success in 11 press lines of five different automotive manufacturers. The feeder is designed for max. 16 SPM. The tooling change is fully automatic using the newly developed locking mechanism in the feeder head and a tooling change carriage with a turning device,...