orm^d Toughened Access Control Solutions M AXS Series - S60 Keypad This mullion format integrated keypad and contactless reader is rated for continuous outdoor use in exposed, unsupervised locations. Featuring genuine HID® iCLASS SE®, Seos®, contactless technology, this access control keypad offers enhanced security by dual factor authentication. Additionally available with HID® multiCLASS SE® for legacy 125kHz technology. Authorized access through a secured door or barrier can be gained by entry of a valid PIN and/or presentation of an authorised contactless credential. Installation Recommended locations and wiring methods shall be in accordance with the National Electrical Code, ANSI/NFPA 70 1. Mark and drill the cable hole. Remove the release liner and stick the rear plate to the wall. 2. Fix to the wall with the 2 x self drill c/s 25mm screws (on 150mm centres) , and feed through the cable 3. Make the wiring connections to the keypad 4. Set the rear halo illumination switch (default is ON, colour is blue) 5. Fit the keypad to the rear plate : locate at top and then push to engage clip (to unclip the keypad insert the supplied tool at the keypad base and push in to disengage the clip) Weigand Format for PIN Factory default is Weigand 4 bit burst format (for PIN). If you need other Weigand formats follow the sequence below. (to set site code on 26/32 bit refer to the S60 Engineering Manual) on power up , LED FLASHES RED/GREEN to enter format mode for FORMAT for 4 BIT FORMAT for 8 BIT FORMAT for 26 BIT FORMAT for 32 BIT FORMAT Specification Card Compatibility Card Read Range Credentials Card Security Coupling Frequency Supply Dimensions Tamper detection Status Indication Access Control iClass® , Mifare® , ISO15693, ISO14443A & B 2-11cm (depending on card) iClass®, SEOS®, Mifare Classic,Plus,Ultralight, Desfire 0.6,EV1, HID Prox V1 Security (Elite to special order only) 13.56 MHz (& 125kHz for Multiclass) 12V DC +/- 15% at 500mA max 205mm H x 45mm W x 21mm D (max) Normally closed RED/GREEN as driven by the Controller (as supported by the controller) Level I for Line Security, Level II for Destructive Attack / Endurance Performance Operational Temp Weather Resistant Vibration & Shock Impact Resistance Certification Order Codes DS601K20 AXS Series S60 iClass keypad, metal keys, mullion format DS602W20 AXS Series S60i iClass keypad, illuminated keys, mullion format DS601K2P AXS Series S60M Multiclass keypad, metal keys, mullion format DS602W2P AXS Series S60iM Multiclass keypad, illuminated keys, mullion format. Datasheet: DS60-xx-08KT Page 1 of 2 For more information visit www.storm-interface. comRev 2 Jan 2018 © Copyright Storm Interface. 2018. All rights reserved

orm^d Toughened Access Control Solutions M AXS Series - S60 Keypad Using the S60 Keypad You will be issued with valid credentials in order to use the keypad: • either an 13.56MHz Card (iClass, MiFare etc), or for Multiclass S60M a 125kHz (HID Prox) card • and also a PIN if required. The status LED is normally RED when the door is locked, and goes GREEN when access is granted Always present the card before entering the PIN. For best results present the card in the same orientation as the antenna The HF antenna is around keys 1 - 6 iClass Card The LF prox antenna is around keys 7 - # Datasheet:...