Cleanbelt
2Pages

Rolled Baking Oven Belts Our Concept of a Good Belt Cleaning (aka Z-Belts) upper brush (coarse) waste recycling bins Brush System small counter roll ® The maintenance free CLEANBELT  cleaning system has been specifically developed for rolled baking oven belts made by Steinhaus. waste recycling bins electrically operated lower brush (fine) Mode of Operation ® The CLEANBELT  cylinder consists of individually mounted sprocket discs combined with intermediate distance rings, which are tuned to the individual mesh structure of each belt. So they work themselves exactly into the mesh opening. The sprocket discs can break up the (cake of) dirt, stuck to the belt’s surface and/ or in the belt meshes. So that the brush system, following the ® CLEANBELT  , can finally remove it. For each free running and unguided belt there are certain movements in the belt’s tracking. Consequently they appear, although to a lesser degree, also with our rolled baking oven belts. To equal these running vari® ations the CLEANBELT  system is freely supported on a stand-alone frame structure and can follow independently the belts (slight) movements to left and right. Our experiences from the field have shown that for many brush systems in operation there is a big potential for improvement, too. Gladly we could offer some assistance in this respect in ® order to achieve in combination with CLEANBELT  the best possible cleaning result for your belt. system works continuously and mechanically nearly maintenance free (only regular cleaning by compressed air or jet water) • Additional manual cleaning of the baking oven belt is either no more necessary or reduced to a minimum at much greater intervals • Improved oven’s heat management at reduced costs • Considerably reduced energy consumption for heating • Longer operational life time, since no more belt changes because of dirt • Suitable for several belt life time cycles • Easy installation since no electric components involved • Investment pays off in a short time STEINHAUS GmbH Platanenallee 46 45478 Mülheim a. d. Ruhr Germany

Case Study from the Field Steinhaus rolled baking oven belts, also known as Z-Belts, are made of round wire spirals with very narrow and equal tolerances. The wire fabric is rolled flat first with greatest care before the belt is cut to width and the edges are spot welded. With this a very smooth, equal and angular belt structure is achieved with the required stability whilst retaining sufficient flexibility. For producing baked durables of all kinds of hard and soft biscuits in particular, rolled baking oven belts are preferred to be used instead of solid steel belts or heavy weight...