Catalogs >
Steel Smith >
Sliding locks for square bar

Sliding locks for square bar
4Pages

Catalog excerpts

SLIDING LOCKS FOR SQUARE BARReHS Body QCSQSP RISER PLATES FOR SLIDING LOCK RaoHS imno Part Number

Features You can slide the steel bar when the knob is at "OFF" position since there is clearance between the steel bar and the shafts. The steel bar is locked when the knob is at "ON" position since the shafts are pushed by the wedge. Shaft Steel Bar 1. The steel bar can slide to right and left at "OFF" position. 2. The steel bar is locked at "ON" position. Note: The knob clicks at "ON" and "OFF" positions, and this enables the operator to lock/unlock securely. Note: Sliding Locks must be mounted when the knob is at "OFF" position. Mounting of Sliding Locks at "ON" position may cause...

Open the catalog to page 2

・Usable Materials: Flat bar (JIS h14 grade) made of SS400, S45C or SUS304 etc. H ■How To Use Riser Plate Riser Plates (to be ordered separately) can lift the steel bar to create a clearance between the steel bar and the base. Riser Plate ■How To Use Tapped Holes On Side Surface Can be used with attachments such as pointer plates and brackets. Screw Size M3×0.5 Note: Screw depth must be 6mm or less. ■How To Use Scale Plate ・Scale plate can be put on the steel bar. Note: Fit scale plate inside the slot in the figure below. Putting scale plate outside the slot cause interference between scale...

Open the catalog to page 3

Performance Curve ■The displacement of steel bar by axial load 　(Static load from single direction) A Note: The above data is for a flat bar made of SUS304 stainless steel, SS400 steel and S45C steel. Using an aluminum flat bar, the surface will be scratched or dent by applied load. Technical Information ・Heat resistance : Up to 90℃ ・Rated load : QCSQ 1212,1616 : Up to 500N Rated load : QCSQ 2509,2512,3212,3216 : Up to 800N Notes ・The displacement will increase with excess shock or vibration. Please contact us for use in such environment. ・The displacement can increase with adhesion or...

Open the catalog to page 4