NXA
1Pages

Fixturlaser NXA Pro System Weight including all standard parts: 7,7 kg (17 lbs) Display Unit Weight: 1,2 kg (2,6 lbs) with battery Horizontal Shaft Alignment Determine and correct the relative position of two horizontally mounted machines that are connected, such as a motor and a pump, so that the rotational centers of the shafts are collinear. Environmental protection: IP 65 (Dust tight and protected against water jets) Display size: Gyroscope: Operating time Battery charging time (system off, room temperature): TD Units 6,5” (165 mm) diagonal (133 x 100 mm) 6-Axis MEMS Inertial Motion Sensor with drift compensation and automatic field calibration. 10 hours continuous use (with 50% LCD backlight) 1 hour charge - 6 hours operating time Vertical Shaft Alignment Determine and correct the relative position of two vertically/flange mounted machines that are connected, such as a motor and a pump, so that the rotational centers of the shafts are collinear. Weight: Dimensions: Environmental protection: Measurement distance: Detector length: Detector resolution: Measurement accuracy: Gyroscope: Operating time: Shaft Brackets 192 g (6,8 oz) with battery 92 mm x 77 mm x 33 mm (3,6 in x 3,0 in x 1,3 in) IP 65 (Dust tight and protected against water jets) Up to 10 m 2nd generation Ultra HD CCD 30 mm (1,2 in) 1 pm 0,3% ± 7 pm 6-Axis MEMS Inertial Motion Sensor with drift compensation and automatic field calibration 17 hours continuous use (measuring) Machine Train™ Alignment Align a set-up of more than two rotating machines that are connected to each other. Softcheck™ Softcheck™ checks if there is a soft foot condition, i.e. when the motor is not resting firmly on all its feet. Target Values Pre-set target values before starting your alignment work when you have determined the machines thermal expansion. Hot Check™ Performing a measurement just after the machine has been shut off, and another measurement when the machine is cold. The Hot Check application is then used to compare these two measurements. The difference between the two measurements can be used as target values when shaft alignment is performed. Machine Defined Data Information such as entered distances, measurement method, target values and tolerances are saved in a template. Shaft diameter: Feetlock™ Solution to solve base-bound and/or bolt-bound machines. Memory Manager Measurements can be organized in folders and subfolders. Single measurements and/or complete data structures can be copied to USB stick.