Catalogs >
STARRETT >
STARRETT-BYTEWISE PROFILOMETER

STARRETT-BYTEWISE PROFILOMETER
4Pages

Catalog excerpts

Measurement Systems for the Tire Industry Profilometer Off-Line Profilometer Off-Line Profilometer SL (PSL) On-Line Profilometer (OLP) Ply Splice Monitor Ply, Belt, and Extrusion Width Monitor Profile360 for Apex Extrusion Green Tire Uniformity (GTU) Circumferential Treadwear Imaging System (CTWIST) Bead-to-Bead Profile Measurement System (B2B) Tire Identification System

Open the catalog to page 1

Profilometer Tread and sidewall extrusions can be no more precise than the dies used to make them. When a new die is cut it should be well-centered, so the Operator has the flexibility to optimize the extruder set-up. After some time in service, die wear can be uneven so that certain areas along the profile get excessive rubber flow. This is a very costly waste of raw materials. Unbalanced flow can also disrupt the symmetry of the tread - a factor that influences cured tire uniformity and balance. The Starrett-Bytewise Profilometer was developed as an automated, non-contact measurement...

Open the catalog to page 2

Operational Overview A. Full Profile View B. Zoom View of Full Profile C. Table View of Conicity Effects Cesgn Measure Em Design LASER MEASUREMENT SOLUTIONS

Open the catalog to page 3

Specifications Measurement Parameter Thickness Measurement Range Width Measurement Range Gage Repeatability on Flat Surfaces Gage Accuracy on Flat Surface Area Calculation Repeatability Area Calculation Accuracy Sample Interval (Width Resolution) Measurement Spot Size Dimensions (W x D x H) Bulletin 2517 - Profilometer Specifications subject to change. © Copyright 2012 PDF 10/12 Corporate Headquarters The L.S. Starrett Company 121 Crescent Street Athol, MA 01331-USA Starrett-Bytewise Measurement Systems 1150 Brookstone Centre Pkwy. Columbus, GA 31904-USA Tel: 706-323-5142 Laser Measurement

Open the catalog to page 4