TECHNICAL DATA SHEET SOLDER WIRE HF32 Designed for use in electronics application Solder wire HF32 has been developed to meet industries increasingly stringent quality requirements. It is a flux cored solder wire. The activated, halide-free flux according J-STD-004 type ROL0 standard. The flux residues are solid and dry, and are not corrosive when tested in accordance with DIN 8516. HF32 can be used for hand-soldering and automatic wire feed operations. For manual soldering, the soldering iron tips should be temperature-controlled, to prevent excessive heat from being applied to the wire. Flux spatter from the formulation is fairly low. Solder wire HF32 meets the requirements of DIN 8516, with respect to surface insulation resistance and electromigration. The flux residues are not corrosive to non-ferrous metals. If cleaning is necessary for optical or technical reasons, we recommend the use of the cleaner Stannol Flux-Ex 200B or Stannol Flux-Ex 500. Other alloys, diameters flux contents or reel sizes are available on request. Before using please read the material safety data sheet carefully and observe the safety precautions described. The above values are typical and represent no form of specification. The Data Sheet serves for information purposes. Any verbal or written advise is not binding for the company, whether such information originates from the company offices or from a sales representative. This is also in respect of any protection rights of third parties, and does not release the customer from the responsibility of verifying the products of the company for suitability of use for the intended process or purpose. Should any liability on the part of the company arise, the company will only indemnify for loss or damage to the same extent as for defects in quality. STANNOL GmbH & Co. KG • Issue: 18.11.2021 Haberstr. 24 • 42551 Velbert • Tel: +49 (0)2051-3120-0 • Fax: +49 (0)2051-3120-111 • E-Mail: [email protected] • www.stannol.de