CT Tools
4Pages

Catalog excerpts

CRIMPING TOOLS CT10 Kearney (not shown) Accepts standard Kearney dies. It is compatible with the following tooling and die application: Small and lightweight tool ideal for service entrance termination and underground crimping. It accepts 90% of available service entrance connectors and accommodates wires up to 4/0 in (13 mm) diameter. Uses an Anderson Die-Less head designed for use with Anderson-style connectors. CT10 Burndy (not shown) Accepts standard Burndy U-type dies. It is compatible with the following tooling and die application: Compatibility Burndy, Y35, L, H Alcoa, 12A, 12AC, 12HA, 12HAC and 30A With its unique C-frame opening of 11/2 inches permits the operator to crimp material up to 750 MCM aluminum or copper cable. The larger opening can eliminate the need for larger, more expen-sive 15 ton tools when crimping large connec-tors that don’t require 15 tons of die load. The CT10 STANLEY® accepts standard Burndy Utype dies. It is compatible with the following tooling and die application: CT15 Burndy(shown) The CT15 head uses die holders that allow the tool to accommodate Burndy tooling. It will accept the following dies: Huskie, EP410, EP410T, EP430, EP510, EP410HT, RP410H, EP510H, PDY-1220 and PDY-1216 Thomas & Betts, 12 Ton Teledyne, TPU-12 BH Stanley Hydraulic Tools | 3810 SE Naef Road | Milwaukie, Oregon 97267 | +01.503.659.5660 | 800.972.2647 | www.stanleyhydra

Open the catalog to page 1

CRIMPING TOOLS Features and Benefits Crimping connectors with the Stanley Hydraulic Tools CT Series crimpers is quick and easy. They are 5-10 times faster than handpumped tools and more than twice as fast as high pres-sure double acting crimpers. Simple and Reliable Design The CT Series of crimpers use few moving parts, provide years of reliable performance, low maintenance, and quick repairs. The CT Crimpers require no booster or intensifier which means they can be operated directly from the hydraulic circuits already installed on your line trucks, or from a dedicated power unit, or from...

Open the catalog to page 2

CRIMPING TOOLS Choosing the Correct Tool For Your Application. • Determine the head type and dies you intend to use. There is a CT head combination that will accept most of the dies you are already using. • Determine the operating pressure of your hydraulic power source. This is important since these tools are designed and built for operation within specific hydraulic sys-tem parameters. • The hydraulic system you intend to use must fall within the following nominal specifications: 1,650 psi/ 114 bar to 2500 psi/172 bar. OPERATION, PERFORMANCE and ORDERING INFORMATION CT10 KEARNEY Tension...

Open the catalog to page 3

CRIMPING TOOLS ORDERING INFORMATION ACCESSORIES Die Holders for CT15036GN Burndy Head Model 33704 Die Holder, 12T Burndy All stanley hydraulic tools, parts, accessories and allied equipment are subject to design improvements, specifi cation and price changes at any time without notice and with no obligation to units already sold. Weights, dimensions and operating specifi cations listed herein are subject to change without notice. Where specifi cations are critical to your application, please consult stanley hydraulic tools. WARRANTY: Stanley Hydraulic Tools and their associated parts are...

Open the catalog to page 4