Installation Tool for Monobolt® Fasteners & Lockbolts 7287 Model Features • Hydro-pneumatic split tool for Monobolt® fasteners and lockbolts • Extended stroke and pull force • Installation of large fasteners with single pull action • Short cycle time • Lightweight placing head • Remote intensifier mounted on castors • 3 m hose length • Wide choice of directly interchangeable 722 model nose assemblies to suit the access restrictions of the application Benefits • Places a wide range of fasteners in one stroke • Does not require second actuation (two pulls) • High placement speed Dimensions (mm/inch) • Can offer labour cost savings • Can increase assembly capacity • Reduces operator fatigue • Flexible use in the assembly line • Can be fitted with a collar cropper to remove installed Avdelok® lockbolts • Reduced noise output during fastener installation Specifications Pistol weight (without equipm.) Pistol weight (with equipm.) Total weight (without equipm.) Pull force @ 5.5 bar Stroke min. under load free cycling Cycle time (approx.) Air supply pressure Free air volume @ 5.5 bar Noise level Vibration Placing capability Avdelok®, Avtainer® and Monobolt® fasteners up to ø 3/8" (10 mm) Avbolt® fasteners up to ø 5/16" (8 mm) All other lockbolts up to ø 5/16" (8 mm) Avseal® II sealing plugs up to ø 14 mm For detailed information on placing capability and nose equipment please refer to the tool manual on our website www.avdel-global.com or contact your local Avdel representative. Avdel UK Limited Pacific House, 2 Swiftfields Welwyn Garden City, Hertfordshire AL7 1LY Tel. +44 (0)1707 292-000 · Fax -199 [email protected] Avbolt , Avdelok , Avseal , Avtainer and Monobolt are trademarks of Avdel UK Limited. Data shown is subject to change without prior notice as a result of continuous product development and improvement policy. Your local Avdel representative is at your disposal should you need to confirm latest information. ®