Fabric over foam CébéPhot These tests were carried out in laboratory conditions which are not representative of working conditions.

Metallised fabric is made from nylon or polyester and covered with a fine metallization. To ensure good mechanical strength and high corrosion resistance, the metallization is protected by a conductive varnish. The fabric is then applied to extruded foam. Gaskets made in this way offer flexibility, lightness and good shielding effectiveness Examples of applications: - Input/Output port (I/O) - Data processing - Broadcast, Telecommunications - 19" system - Front panel, plug-in module Advantages: - Flexible - Multitude of contact points - Nonabrasive - Economical - Cutting to required dimensions...

Rectangular profiles Part number Part number These tests were carried out in laboratory conditions which are not representative of working conditions.

Square profiles Part number Profiles in D Part number Part number These tests were carried out in laboratory conditions which are not representative of working conditions.

Part number * with bump between adhesive Part number Available with foam type 1 and 2 * without bump between adhesive Part number *Available with foam type 1 and 2. Part number These tests were carried out in laboratory conditions which are not representative of working conditions.

Profiles in P, C and Knife-edge Part number * without insert Part number Part number Part number Part number * without insert These tests were carried out in laboratory conditions which are not representative of working conditions.

Profiles with clips Part number Part number Part number List of non-exhaustive profile These tests were carried out in laboratory conditions which are not representative of working conditions.

EPDM profiles covered with metallised fabric Part number The use of these gaskets makes it possible to achieve a sealing level= IP55 (according to test IEC529) * The fabric only covers half the EPDM gasket. This solution has the advantage of insulating the conducting part of the exterior environment, thus protecting it against corrosion. The conductive fabric can cover the profile from above or from below the profile (7G6 and 7G8 profile only) Cover from above Cover from below These tests were carried out in laboratory conditions which are not representative of working conditions.

Fabric over foam Joints entrée / sortie Sub-D Sub-D 9pts Part number H091 (in 1,0mm) H092 (in 2,0mm) Sub-D 15 pts Part number H151 (in 1,0mm) H152 (in 2,0mm) Sub-D 25pts Part number H251 (in 1,0mm) H252 (in 2,0mm) Sub-D 37pts Part number H371 (in 1,0mm) H372 (in 2,0mm) Sub-D 50 pts Part number H501 (in 1,0mm) H502 (in 2,0mm) Other cutting on request: - width of 50mm to 178mm (standard profile) - width of 178mm to 400mm (special profile) These tests were carried out in laboratory conditions which are not representative of working conditions.

Fabric over foam Tolerances Tolerances on standard length 0,1mm à 12,7mm Part number example: TM H = Micro cellular PU, covered with 50% of fabric (according to profile) R = Railway variant profiles 7Gx. Compliance with EN45545-2 or EN50121 with fabric 0 = without PSA 1 = with 1 nonconductive PSA 2 = with 1 conductive PSA 3 = 2 rows of nonconductive PSA 4 = specific positioning of the adhesive 5= Recovery of the fabric from above (7G6 and 7G8 profile) 6= Recovery of the fabric from below (7G6 and 7G8 profile) Profil part number : 1 = UL94HB 2 = UL94V0 3 = UL94V0 ultra soft halogen free 4 = UL94V0...