Assembling and printing system for humidification chambers and breathing masks This machine concept was developed for In-Line production of humidification chambers and breathing masks. The machine is build for swaging and printing of the humidification chambers. The single parts as: bottom, seal, floater and chamber are assembled and loaded into the jig of the servo – linear transport system. In the first station the bottom will be swaged. In the next station the chambers are positioned in such a way that the print comes to the correct position. The pad printing machine is equipped with two sealed inkpots and with one automatic pad cleaning unit. In the first printing station the chambers are printed at the top and in the second station the chamber are turned by 90° and the printed on the side. After printing the chambers goes back to the upright position and the linear-slide goes back with the chamber to the start position. ______________________________________________________________________________________ ST Drucksysteme, Blattenweg 1, CH-8235 Lohn / Switzerland / Tel: 052 670 1434, Fax: 052 670 1436 http//www.stsprint.com / http//www.stds.ch / E-Mail: [email protected]

Loading: Loading station with rotating plate and turn device. Bördelstation: Bördelstation with pressure, swaging station. Position station: Position station for the identification of 3 or 4 tube connetions. The positioning happens by optical sensors. First printing station: In this station the top of the chambers are printed. Second printing station: In this station the chambers are printed on the sides. The jig turned in the second printing station by a pneumatic cylinder for 90° The chamber is fixed in a . jig. After printing the jig move back in the upright position. . By a few hand gripps...