InfraCal 2 Analyzers
2Pages

InfraCal 2 AnalyzersMEASURING OIL IN WATER & SOIL APPLICATIONS ■ Testing produced water on offshore or onshore oil rigs ■ Monitoring refinery or industrial plant wastewater effluents ■ Measuring FOG discharge levels ■Checking oil/water separation systems ■Measuring oil in drilling mud/cuttings ■Testing for residual oil on pre-cleaned metal components ■ Determining the purity level of reclaimed solvents ■ Onsite testing of soil at remediation sites FEATURES ■ Results in less than 15 minutes ■ Sub-ppm measurements ■Rugged, portable, easy-to-use ■Internal data logging ■ Export via USB ■Multiple calibrations Over 4,000 oil in water/soil analyzers in world-wide use today The InfraCal 2 Oil in Water Analyzers quickly and accurately measure TOG (total oil & grease), FOG (fats, oil and grease) and TPH (total petroleum hydrocarbons) in produced water, industrial wastewater and soil. InfraCal 2 analyzers have become the petrochemical industry standard ensuring oil content levels in produced water, drill cuttings or soil are below the regulated limit. The InfraCal 2 ATR-SP is recommended for measuring oil in water, TPH in soil or FOG in wastewater concentration levels when using hexane, pentane or Vertrel MCA as the extracting solvent. Measurement data obtained with this analyzer will correlate to EPA Method 1664 as both procedures are based on evaporation techniques and measuring the residual oil and grease. The analyzer is equipped with a built-in cubic zirconia horizontal attenuated total reflection (HATR) stainless steel sample stage. The InfraCal 2 TRANS-SP is recommended for measuring oil in water, TPH in soil or FOG in wastewater concentration levels using the traditional EPA methods 413.2 and 418.1 or ASTM method D7066-04 and Freon-113, hydrocarbon-free grade of perchloroethylene, AK-225, S-316 or other spectroscopic infrared transparent solvent as the extracting solvent. Since the extract is deposited into a 10 mm quartz cuvette cell with Teflon stopper, light end volatile components are retained for measurement. Accurate down to 0.1 ppm. Solvent Hexane, pentane, Perchloroethylene, Principle of Operation The InfraCal 2 Analyzers for measuring total oil and grease and total petroleum hydrocarbons in water and soil makes use of the fact that hydrocarbons such as oil and grease can be extracted from water or soil through the use of an appropriate solvent and extraction procedure. The extracted hydrocarbons absorb infrared energy at a specific wavelength and the amount of energy absorbed is proportional to the concentration of oil and grease in the solvent. The analyzer can be calibrated to read out directly in the desired units.

Spectra Scientific Confidence in knowing AMETEK Spectro Scientific | One Executive Drive, Suite 101, Chelmsford, MA 01824-2563 978-431-1120 | www.spectrosci.com | sales@spectrosci.com | An ISO 9001:201 5 company Copyright © 2018 Spectro Scientific. All rights reserved. While every effort is made to assure the information in this document is accurate, Spectro Scientific does not accept liability for any errors or mistakes that may arise. Specifications are subject to change without notice.