0162 • 0163 DIGISPEC PROXIMITY/ZERO SPEED H SENSOR SINGLE & DUAL OUTPUT MAGNET ACTUATED PRODUCT DESCRIPTION SPECTEC's Proximity/Zero Speed position sensors are designed to switch in the presence of a low magnetic field. Bi-polar (north and south polar activation) is standard. Uni-polar and Omni-polar activation is also available for higher pulse resolution. Various output options are available and provided to suit all interface requirements. A robust universal sink/source NPN/PNP low impedance rail-to-rail output with 60V automotive load dump and short circuit/reverse voltage protection is also available. The sensor is reverse polarity protected. For intrinsically safe versions refer to bulletins: IS160 & IS161. SPECIFICATIONS Orientation: Single: No orientation required. Dual: For directional applications, the alignment mark must be in line with the rotation of the target. For synchronous output, the alignment mark should be at a right angle to the rotation of the target. 4.0 to 30 Vdc @  18 mA 10-36 Vdc for Universal sink/source output Reverse Polarity Protected .160” Typically  1” using extra strong 5K Gauss mags Standard: 0 to ~20 kHz (for precision position applications) High Speed: 0 to ~100 kHz (for high speed only) Output signal is typically ‘Normally High’, except for PNP output which is ‘Normally Low’ Operating Freq.: Temperature Range: 3/4-16 UNF w/ 1/2-14 NPT Male 3/4-20 UNEF w/ 1/2-14 NPT Male *May be reduce based on configuration *May be reduce based on configuration 300 Series S.S. Housing & Face Solid Encapsulation See Page 2 All have Gold Plated Contacts Lead Wire & Assignments: See Page 2 for Wire & Cable Options 2TE: PVC 22-24 AWG (105°C) 3TE: TFE 22 AWG (150°C) Red: Supply (+) Black: Common (-) White: Signal A Green: Signal B (dual sensor only) Bare: Shield OPTIONS Custom configurations, special materials of construction, thread sizes, special output circuits (including short cicuit protection), temperature probe (NTC10, RTD100, or others). Please contact sales. 4/21/17, REV. 2 3/4-16 UNF w/ 1/2-14 NPT Female 3/4-20 UNEF w/ 1/2-14 NPT Female A

Thread Length(A): Temperature Range: Sensor Type: SINGLE SENSOR (HF) PINOUT MS3 Vo Thread (A) & Housing (L) Length: 5/8” Wrench Flats on all 4”and longer fully threaded sensors 1. Optional 5/8” hex Wrench flats are designated by adding an “H” after the 4 digit base number. 2. A Normally Low output signal is available for the NPN output signal option (TTL, Supply Tracking and Open Collector) by adding ‘-NL’ to the end of the Part Number. Similarly, a Normally High output signal is available for the PNP output signal option by adding ‘-NH’ to the end of the Part Number. SAME AS ABOVE Notes: DUAL...