0160• 0161 DIGISPEC PROXIMITY/ZERO SPEED H SENSOR SINGLE & DUAL OUTPUT MAGNET ACTUATED PRODUCT DESCRIPTION SPECTEC’s Proximity/Zero Speed position sensor are designed to switch in the presence of a low magnetic field. Bi-polar (north and south polar activation is standard. Uni-polar and omni-polar activation is also available for higher pulse resolution. Various output options are available and provided to suit all interface requirements. A robust universal sink/source NPN/PNP low independence rail-torail output protection is also available. The sensor is reverse polarity protected. For intrinsically safe versions refer to bulletins: IS160 & IS161 SPECIFICATIONS Orientation: Single: No orientation required. Dual: For directional applications, the alignment mark must be in line with the rotation of the target. For synchronous output, the alignment mark should be at a right angle to the rotation of the target. Output signal is typically ‘Normally High’, except for PNP output which is “Normally Low’ See note on Page 2 for more information Operating Freq.: Standard: 0 to 20 kHz (for precision position applications) High Speed: 0 to 100 kHz (for high speeds only) 4.5 to 30 Vdc @  18 mA Reverse Polarity Protected 10-36 Vdc for Universal sink/source output  .160” typical  1” using extra strong 5 kG magnets Rise/Fall Time: Temperature Range: *may be reduced based on configuration *may be reduced based on configuration See Page 2 All have gold plated contacts Lead Wire Assignments: Red: Black: White: Green: Bare: 300 series stainless steel housing Solid epoxy encapsulation CE-Compliance: OPTIONS Supply (+) Common (-) Signal A Signal B (dual sensor only) Shield: not connector to sensor shell, ground at termination. Custom configurations, thread sizes, special materials of construction, temperature probe (NTC10, RTD100, or others). For directional sensing, a dual sensor can be used with P/N 4033.

ORDER INFORMATION STYLE: Thread Length(A): Thread Length(A): *for shorter lengths, single leads are also available. Thread Length(A): Note: A Normally Low output signal is available for the NPN output signal option (TTL, Supply Tracking and Open Collector) by adding '-NL' to the end of the Part Number. Similarly, a Normally High output signal is available for the PNP output signal option by adding '-NH' to the end of the part number. 4/21/17, Rev. 3 MS3102-10SL-4P(For two wire current loop, See Bulletin 3000) MS3106-10SL-3P (See Bulletin 3000) Micro-C (See Bulletin 3004) MS3102-10SL-3P (See Bulletin...