*mydirectindustry

SPT300PFB

Product catalog summary

Overview: The SPT300PFB is a 300 Watts AT Switching Power Supply by Sparkle Power Inc., compliant with RoHS standards. It is designed for high efficiency and reliability, featuring active power factor correction and compatibility with European Union Directive 2002/95/EC.

Input Characteristics:

Input Range: 90 ~ 264Vac (RMS), Full Range Input
Frequency: 50 ~ 60Hz
Input Current: Max 7A (RMS) @ 115Vac, 3A (RMS) @ 230Vac
Inrush Current: No damage

Features:

Complies with AT standard
Active Power Factor Correction (PFC) meets EN61000-3-2
Remote ON/OFF function
Internal 12V DC fan included
Low noise and ripple
Output over voltage, short circuit, and over current protection
100% Hi-pot, ATE, and burn-in tested
Re-settable power shut down

Specifications:

Operating Temperature: -30°C ~ +50°C; Storage: -20°C ~ +80°C
Humidity: 5 ~ 95% for both operating and storage
Dielectric Withstand: 1800V AC for 1 second
Efficiency: 75% minimum, typical up to 80%
Rise time: Less than 20ms
Hold-up Time: 17ms minimum at nominal input voltage
Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum
Leakage Current: Less than 3.5mA at 264Vac, 50Hz
MTBF: 100,000 hours at maximum load at +25°C
Dimensions: 140x150x86mm / 5.5x5.9x3.4inch
Compliance: FCC part 15 subpart J class B, CISPR 22 class B, UL, CSA, TUV, VDE, EMC, FCC, CE, CB report

Output Characteristics:

+5V: Min Load 2.0A, Normal Load 20A, Max Load 40A, Load Reg. ± 5%, Ripple & Noise 50mV P-P
+12V: Min Load 1.0A, Normal Load 7.5A, Max Load 15A, Load Reg. ± 5%, Ripple & Noise 120mV P-P
-5V: Min Load 0.0A, Normal Load 0.15A, Max Load 0.3A, Load Reg. ± 10%, Ripple & Noise 50mV P-P
-12V: Min Load 0.0A, Normal Load 0.4A, Max Load 0.8A, Load Reg. ± 10%, Ripple & Noise 120mV P-P
Total output not to exceed 290W for +5V and +12V, total output 300W

Contact Information:

Main Office: 1000 Rock Avenue, San Jose, CA 95131, TEL: 408-519-8888, FAX: 408-519-9999, E-MAIL: [email protected]
Los Angeles Office: 17071 Green Drive, City of Industry, CA 91745, TEL: 626-839-7180, FAX: 626-839-3395

Catalog excerpts

Sparkle Power Inc. A Leading Power Supply Manufacturer Web site: www.sparklepower.com SPT300PFB (RoHS Compliant) 300 Watts AT Switching Power Supply Features • Complied with AT standard Active Power Factor Correction (PFC) meet EN61000-3-2 High efficiency and reliability Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances). • Remote ON/OFF function Output over voltage, short circuit, and over current protection 100% Hi-pot, ATE, and burn-in tested Re-settable power shut down Complies with FCC part 15 subpart J class B 115Vac operation, Humidity: 5 ~ 95% on operating, 5 ~ 95% on storage Dielectric Withstand: Primary frame ground 1800V AC for Temperature Range: Operating: -30°C ~ +50°C; storage & Efficiency: 75% minimum, typical up to 80% Rise time: Less than 20ms Hold-up Time: 17ms minimum at nominal input voltage Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible) and CISPR 22 class B at 230Vac operation Approved by UL,CSA22.2 NO or CUL 60950-1, TUV or VDE, EMC,FCC ,CE, CB report. Leakage Current: Less than 3.5mA at 264Vac,50Hz MTBF: 100,000 hours on maximum load at +25°C Input Characteristics Input Range: 90 ~ 264Vac (RMS), Full Range Input Frequency: 50 ~ 60Hz Input Current: Max 7A (RMS) @ 115Vac, 3A (RMS) @ 230Vac Inrush Current: No damage Output Characteristics Output Voltage Minimum Load Normal Load 2.0A 20A +5V 1.0A 7.5A +12V 0.15A 0.0A -5V 0.0A 0.4A -12V *+5V and +12V total output not exceed 290W * Total output for this subject power supply is 300W Sparkle Power Inc. Main Office 1000 Rock Avenue San Jose, CA 95131 TEL: 408-519-8888 FAX: 408-519-9999 E-MAIL: [email protected] Sparkle Power Inc. Los Angeles Office 17071 Green Drive City of Industry, CA 91745 TEL: 626-839-7180 FAX: 626-839-3395

Open the catalog to page 1

SPT300PFB

SPT300PFB

Catalog excerpts

All Sparkle Power catalogs and technical brochures

Archived catalogs