1. Catalogs
  2. Sparkle Power
  3. FSP2000-52AGPBI

FSP2000-52AGPBI

FSP2000-52AGPBI

Product catalog summary
Input Characteristics
Input Range: 100 ~ 264Vac (RMS), Full Range Input
Frequency: 47 ~ 63Hz
Input Current: Max 15A(RMS)@ 115Vac, 12A(RMS)@ 240Vac
Inrush Current: No damage at cold start
Specifications
Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C
Humidity: 10~90% on operating, 95% on storage
Dielectric Withstand: Primary frame ground 3000Vac for 3 seconds
Efficiency: Typical > 92%
Altitude: Suitable for tropical climates and use at altitudes not exceeding 5000M above sea level
5Vsb efficiency: Meets ENERGY STAR 5.0 and ErP requirements
Rise time: Less than 20ms
Hold-up Time: 17 ms minimum at nominal input voltage
Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
Leakage Current: Less than 3.5mA at 264Vac, 63Hz
MTBF: A minimum predicted MTBF (MIL-HDBK-217) of 100,000 hours of continuous operation at +25°C
Dimensions (LxWxH): 200x150x86mm / 7.88x5.91x3.39inch
Output Characteristics
Output Voltage Minimum Load Maximum Load Load Regulation Ripple & Noise
+3.3V 0A 25A ± 5% 50mV P-P
+5V 0.1A 25A ± 5% 50mV P-P
+12V 0.1A 166.6A ± 5% 120mV P-P
-12V 0A 0.5A ± 10% 120mV P-P
+5Vsb 0A 4.0A ± 5% 50mV P-P
Maximum continuous total DC output power should not exceed 1500W at 115-200Vac and 2000W at 200-264Vac. Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 150W.
Product Information
Model: FSP2000-52AGPBI
Compliance: Meets 80 plus Platinum, RoHS Compliant
Power: 2000 Watts ATX 12V Switching Power Supply
Manufacturer: Sparkle Power Inc.
Main Office: 48502 Kato Road, Fremont CA 94538
Contact: TEL: 408-519-8888, FAX: 408-519-9999, E-MAIL: [email protected]
Los Angeles Office: 17071 Green Drive, City of Industry, CA 91745
Contact: TEL: 626-839-7180, FAX: 626-839-3395
Features
Full Modular Design
Active Power Factor Correction (PFC) meets EN61000-3-2
High efficiency and reliability
Compatible with European Union Directive 2011/65/EU & (EU)2015/863 (Restriction on Hazardous Substances)
Remote ON/OFF function
Internal 12V DC fan included
Support for Max. 16 Graphics cards (16 x PCI-E 6+2 pin)
AC input I/O switch included
Low ripple-noise
Output over voltage, short circuit, over current, under voltage, and over temperature protection
100% Hi-pot, ATE, and burn-in tested
Re-settable power shut down
Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
Approved by CB 62368 & 60950, EMC. CUL/UL TUV, FCC
Manufacturer Information
Sparkle Power Inc. is a leading power supply manufacturer. More information can be found on their website: www.sparklepower.com
See more

Catalog excerpts

FSP2000-52AGPBI-1

Sparkle Power Inc. A Leading Power Supply Manufacturer Web site: www.sparklepower.com Meet 80 plus Platinum, RoHS Compliant 2000 Watts ATX 12V Switching Power Supply • Full Modular Design. • Active Power Factor Correction (PFC) meet EN61000-3-2 • High efficiency and reliability • Compatible with European Union Directive 2011/65/EU & (EU)2015/863 (Restriction on Hazardous Substances). • Remote ON/OFF function • Support Max. 16 Graphics cards (16 x PCI-E 6+2 pin) • AC input I/O switch is included. • Output over voltage, short circuit, over current, under voltage and over temperature protection. • 100% Hi-pot, ATE, and burn-in tested • Re-settable power shut down • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation Input Range: 100 ~ 264Vac (RMS), Full Range Input Frequency: 47 ~ 63Hz Input Current: Max 15A(RMS)@ 115Vac, 12A(RMS)@ 240Vac Inrush Current: No damage at cold start • Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C • Humidity: 10~90% on operating, 95% on storage • Dielectric Withstand: Primary frame ground 3000Vac for 3 second. • Altitude: Applied for tropical Climates and use at altitudes not exceeding 5000M above sea level. • 5Vsb efficiency: 5Vsb efficiency shall meet ENERGY STAR • Rise time: Less than 20ms • Hold-up Time: 17 ms minimum at nominal input voltage • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible) • Leakage Current: Less than 3.5mA at 264Vac, 63Hz • MTBF:A minimum predicted MTBF (MIL-HDBK-217) of 100.000 hours of continuous operation at +25°C. 1. Maximum continuous total DC output power should not exceed 1500W at 115-200Vac. 2. Maximum continuous total DC output power should not exceed 2000W at 200-264Vac. 3. Maximum continuous combined load on +3.3VDC and +5VDC outputs shall not exceed 150W. 17071 Green Drive City of Industry, CA 91745 TEL: 626-839-7180 FAX: 626-839-3395 Sparkle Power Inc. Main Office

 Open the catalog to page 1

All Sparkle Power catalogs and technical brochures

  1. FSP2400-20FM

    2  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.