FSP1000-50ADB

FSP1000-50ADB

Product catalog summary
Input Characteristics
Input Range: 90 ~ 264Vac (RMS), Full Range Input
Frequency: 47 ~ 63Hz
Input Current: Max 17A(RMS) @ 115Vac, 8.5A(RMS) @ 230Vac
Inrush Current: No damage at cold start
Specifications
Temperature Range: Operating: 0°C ~ +50°C, Storage & shipping: -20°C ~ +80°C
Humidity: Operating: 10~90% RH, Non-condensing; Storage: 95% RH, Non-condensing
Dielectric Withstand: Primary frame ground 1800V AC for 2 seconds
Efficiency: Typical > 90%
Altitude: Operation Altitude: 5000 meters above sea level
Standby Power consumption (5Vsb): Not specified
Rise time: Less than 20ms
Hold-up Time: 17 ms minimum at 80% full load
Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
Leakage Current: Less than 3.5mA at 264Vac, 63Hz
MTBF: A minimum predicted MTBF (MIL-HDBK-217) of 100,000 hours of continuous operation at +25°C
Dimensions (LxWxH): 190x150x86mm / 7.49x5.91x3.4inch
Output Characteristics
Output Voltage: +3.3V, +5V, +12V, -12V, +5Vsb
Minimum Load: 0A for +3.3V, 0.1A for +5V, 0.2A for +12V, 0A for -12V, 0A for +5Vsb
Maximum Load: 30A for +3.3V and +5V, 83A for +12V, 0.8A for -12V, 4A for +5Vsb
Load Regulation: ± 5% for +3.3V, +5V, +12V, +5Vsb; ± 10% for -12V
Ripple & Noise: 50mV P-P for +3.3V, +5V, +5Vsb; 120mV P-P for +12V, -12V
Total output not to exceed 150W for +3.3V and +5V
Total output for power supply: 1000W
Compliance and Features
Meets 80 PLUS Gold, RoHS Compliant
Full modular cable management
Active Power Factor Correction (PFC) meets EN61000-3-2
High efficiency and reliability
Compatible with European Union Directive 2011/65/EU & (EU)2015/863
Remote ON/OFF function
Internal 12V DC fan included
AC input I/O switch
Low noise and ripple
Output over voltage, short circuit, and over current protection
100% Hi-pot, ATE, and burn-in tested
Re-settable power shut down
Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
Approved by CB 62368 & 60950-1 2nd, EMC. UL TUV, FCC
Contact Information
Sparkle Power Inc.
Main Office: 48502 Kato Road, Fremont CA 94538
TEL: 408-519-8888, FAX: 408-519-9999, E-MAIL: [email protected]
Los Angeles Office: 17071 Green Drive, City of Industry, CA 91745
TEL: 626-839-7180, FAX: 626-839-3395
Website: www.sparklepower.com
See more

Catalog excerpts

FSP1000-50ADB-1

Sparkle Power Inc. A Leading Power Supply Manufacturer Web site: www.sparklepower.com • Full modular cable management. • Active Power Factor Correction (PFC) meet EN61000-3-2 • High efficiency and reliability • Compatible with European Union Directive 2011/65/EU & (EU)2015/863 (Restriction on Hazardous Substances). • Remote ON/OFF function • With AC input I/O switch. • Output over voltage, short circuit, and over current protection • 100% Hi-pot, ATE, and burn-in tested • Re-settable power shut down • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation Input Range: 90 ~ 264Vac (RMS), Full Range Input Frequency: 47 ~ 63Hz Input Current: Max 17A(RMS) @ 115Vac, 8.5A(RMS) @ 230Vac Inrush Current: No damage at cold start • Humidity: operating: 10~90% RH, Non-condensing, • Altitude: Operation Altitude : 5000 meters above sea level. • Standby Power consumption (5Vsb): • Hold-up Time: 17 ms minimum at 80% full load. • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible) • Leakage Current: Less than 3.5mA at 264Vac, 63Hz • MTBF:A minimum predicted MTBF (MIL-HDBK-217) of 100,000 hours of continuous operation at +25°C. * +3.3V and +5V total output not exceed 150W * Total output for this subject power supply is 1000W 17071 Green Drive City of Industry, CA 91745 TEL: 626-839-7180 FAX: 626-839-3395 Sparkle Power Inc. Main Office

 Open the catalog to page 1

All Sparkle Power catalogs and technical brochures

  1. FSP2400-20FM

    2  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.