*mydirectindustry

NY-N6

Product catalog summary

Overview: This document provides technical specifications and installation guidelines for SOUTHCO® Self-Clinching products, specifically focusing on NY DZUS® Q-Latch Quarter-Turn Fasteners.

Specifications:

Materials: Acetal copolymer resin (black), Polycarbonate (white and black), Polysulfone (black and white).
Grip Range: Four options ranging from 1.50 - 6.88 mm.
Dimensions: Provided in both millimeters and inches.

Installation Guidelines:

Self-clinching fasteners require a properly prepared hole for installation.
Material hardness should not exceed SOUTHCO® recommendations.
Mounting holes can be drilled, punched, or cast, with specific requirements for edge sharpness and diameter.
Minimum distance from the panel edge should be 1.5 times the diameter of the mounting hole.
Panel thickness must meet or exceed minimum recommendations to avoid deformation.

Installation Process:

Insert assembly into the outer panel and strike the head to captivate it.
Turn the stud 90 degrees to latch and unlatch.
Slide the wing into the slot if applicable.

Best Practices:

Use parallel-acting presses and appropriate force for installation.
Avoid using hammers to prevent uneven force distribution.
Install after plating or finishing the panel, ensuring hole specifications are met beforehand.

Catalog excerpts

NY DZUS® Q-Latch Quarter-Turn FastenersAssembly -11. 4 (.45) • Surface install • Panel mounted assembly Material and Finish Acetal copolymer resin, black jl Plunger -Grommet Grommet wing CONNECT • CREATE • INNOVATE Optional Wing (order separately) NY - H6 - F] -► F Finish •<- NY Q-latch Installation notes 1. Insert assembly into outer panel. 2. Strike head of assembly to captivate assembly into outer panel. 3. Turn stud 90 degree to latch and unlatch. 4. Slide wing into slot _Part Number Selection Latch assembly shipped as one piece Wing must be ordered separately Dimensions in millimeters (inch) unless otherwise stated

Open the catalog to page 1

Installation Guidelinesfor SOUTHCO Self-Clinching products Self-clinching product installation is offered on side these Punch Ferrule ® of panel Rollover SOUTHCO products, making them easy-to-use captive Area of material that Material panel fasteners: moves into groove thickness Panel • Captive Screws Die side Mounting hole of panel • Receptacles for Quarter-turn Fasteners Mounting hole • Receptacles for Fast-lead Thread Screws diameter Panel edge • Spring-loaded Plungers • Captive Nuts Ferrule • Threaded Area of material Inserts When pressed into a properly prepared hole, self-clinching captive...

Open the catalog to page 2

NY-N6

NY-N6

Catalog excerpts

All SOUTHCO catalogs and technical brochures

Archived catalogs