CXM3572ER
1 / 14Pages

Catalog excerpts

SP10T Antenna Switch Module for 8TRx/2Tx CXM3572ER Description The CXM3572ER is a SP10T antenna switch module for GSM/UMTS/CDMA/LTE multi-mode handset. The CXM3572ER has a built-in dual low pass filter and a +1.8 V CMOS compatible decoder. The Sony GaAs junction gate pHEMT (JPHEMT) MMIC process is used for low insertion loss and high linearity. The device has low BOM with no DC blocking Capacitor. 0.45 dB (Typ.) TRx (Cellular Band) 0.60 dB (Typ.) TRx (IMT Tx Band) High Linearity: No DC Blocking Capacitors (Except sourcing DC bias) Small Package Size: Lead-Free and RoHS Compliant Structure GaAs Junction Gate pHEMT (JPHEMT) MMIC Switch, CMOS Decoder Absolute Maximum Ratings ◆ Supply voltage This IC is ESD sensitive device. Special handling precautions are required.

Open the catalog to page 1

Block Diagram SP10T Antenna Switch Module

Open the catalog to page 2

Truth Table State Active Path CLTA CTLB CLTC CTLD F1 (*1) State ”L” means a switch “OFF”, State ”H” means a switch “ON”

Open the catalog to page 3

DC Bias Conditions (Ta = 25 °C) Item

Open the catalog to page 4

Electrical Characteristics VDD = 2.5 V, Ta = 25 ˚C Item Insertion Loss

Open the catalog to page 5

Tx2 - ANT IMD2 IMD3 Inter Modulation Product Power in Rx Band Switching Time Supply Current Control Current Active mode Electrical Characteristics are measured with all RF ports terminated in 50 Ω. Corresponding Band of TRx (UMTS / CDMA) *1 Pin = 26 dBm, (Band 1 Tx, Band 2 Tx, Band 3 Tx, Band4 Tx) *13 Measured with the recommended circuit 1

Open the catalog to page 7

Band Band 1 Band 5

Open the catalog to page 8

Electrical Characteristics of Triple Beat Ratio VDD = 2.5 V, Ta = 25 °C Condition Triple Beat Ratio Triple Beat Product at TRx [MHz] Electrical characteristics are measured with all RF ports terminated in 50 . Measured with the recommended circuit 1 Electrical Characteristics of Input IP2 VDD = 2.5 V, Ta = 25 °C Condition IM2 Product at TRx [MHz] Electrical characteristics are measured with all RF ports terminated in 50 . Measured with the recommended circuit 1

Open the catalog to page 9

*1: No DC blocking capacitors are required on all RF ports. *2: DC levels of all RF ports are GND. *3: L1 (22 nH) and C1 (10 pF) are recommended on Ant port for ESD protection. *4: C2 (100 pF) is recommended. Operation Frequency Range: 0.7 to 2.7 GHz

Open the catalog to page 10

VQFN-24P-11 Macro drawing (Reference) * Metal mask thickness : M 0 um : Mask (Open area; I : Resist (Open area)

Open the catalog to page 11

a 1) Baan^htt [Maxairraid) seats.__ d^J-K (2iab'-?^jiffl4f-y l-Bt^a) £Kf*&._ DETAIL B II LOT HO. i HAH 3 CH^BACTEHS ■ MESIAL CODE ) IN SECTION t._ HAHUF^CTURIHC TEAR IS DISPUTED IT FOLLOIIHG lYNHBI BIT S¥STEM. )_ A If E Jh R CODE 1 THE 1ST B11 CF A BlNART SrSTEH BIT SYSTEN IS 0I SPLAfED IN I DOT ] IN SECTION a. A YEAR CODE [ THE ?NB BIT OF A BlNART SfSTfH BIT SYSTEM IS DISPLACED IN I DOT 1 IN SECTION h. n YEAR CODE [ THE IRC BIT CF A BINARY SfSTEH BIT SYSTEM IS 01SPLAIfED IN 1 DOT UN SECTION c A YEAR CODE 1 THE 4TH BIT CF A BINART SfSTEH BIT SYSTEM IS QISPLArED IN 1 DOT ) IN SECTION d. j\...

Open the catalog to page 13

Note Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits

Open the catalog to page 14