The safest and most versatile probes available on the market! Liquid carry over from the pipeline into the sample conditioning system should be prevented when sampling natural gas as it can directly impact the accuracy of the compositional analysis and also damage the analyzer. Industry standards state that equipment used to remove liquid from the sample must be operated at flowing temperature and pressure conditions. Genie® Probes™ provide a means to insert Genie® Membrane Technology™ directly into a pipeline for the purpose of separating unwanted liquid and particulate from the gas sample at flowing temperature and pressure conditions, in compliance with industry standards. The GP2™ probe consists of a housing and a membrane tip probe. The housing is installed in a depressurized pipeline through a vertically mounted thread-o-let or flange, and contains a “foot valve” in its lower end. Inserting the probe into the housing opens the “foot valve”, allowing pipeline gas to flow freely through the membrane. Retracting the probe from the housing closes the foot valve, making it possible to perform probe maintenance without depressurizing the pipeline. This insertion/retraction method is considerably less expensive and complex than pneumatic or hydraulic methods. An optional hex adapter is available to prevent liquids from being forced through the membrane, and should be selected when the probe is being used in spot and composite sampling applications. Technical Specifications Maximum Pressure Rating Temperature Ranges * Actual limit depends on sealing material chosen. Refer to Temperature Range Comparison Chart. Maximum Recommended Flow Rate Type 6 Best Rejection: 4.1 LPM (8.7 CFH) Type 7 Highest Temps: 7.6 LPM (16.1 CFH) Internal Volume Outlet Port Size GP2 with Hex: 1/4” FNPT GPCSA: 3/4” FNPT GP2 without Hex: 1/8” FNPT Results in approx. 2 PSI pressure differential. For higher flow rates, contact the factory. (actual conditions) (actual conditions) Process Connection Thread-o-let Requirement The inner diameter of all openings in pipe wall and thread-o-let must not be less than 0.910”. Mounting Orientation Vertical (Preferred), or 45˚ maximun angle relative to vertical required Wetted Materials Machined parts: 316/316L stainless steel / ISO 15156-3 compliant All other metal parts: stainless steel / ISO 15156-3 compliant Foot Valve sealing material: Perfluoroelastomer Probe sealing material: User defined Membrane: inert Product Brief Applications •  Extract a representative sample from a multi-phase gas source •  Spot, composite or continuous gas sampling •  Protection against liquids •  Online and portable analyzers •  BTU, H2S, Moisture, and others •  Gas sampling of mixtures containing less than 30% hydrogen Benefits •  API 14.1, GPA 2166 and ISO 10715 probe compliance •  Helps to preserve sample integrity •  Protects analyzers •  Helps to improve safety of personnel and equipment •  Does not require hydraulic fluid •  Probe maintenance without line depressurization Features •  Genie® Membrane Technology™ •  Vibration resistant •  No dead volume •  Low internal volume

Model Numbering & Additional Part Numbers Your model number is determined by your specific needs. Choose options below. GP2 = Probe w/ 1/8” FNPT outlet Model Sealing material GPCSA = Probe w/ adapter for YZ, PGI, & Welker Sampler 0 = Neoprene J = RGD resistant HNBR 6 = Better Rejection; Rejects ALL types of liquids from vapor 7 = Highest Temps; Rejects ONLY high surface tension liquids Membrane type Probe housing length Process connection Outlet option H= Hex adapter with ¼” NPT Outlet Port Membrane replacement (other materials available upon request) (contains 2 complete assemblies - sold separately)...