Catalogs >
SMW AUTOBLOK >
VNK-T2

VNK-T2
1 / 3Pages

Catalog excerpts

Application/customer benefits • Actuation of open center jaw and collet power chucks • Machining of bars and tubes Technical features • Pressure range 8-45 bar • Short design/low mass/low power consumption • Horizontal installation only • Safety valves and excess pressure relief valve • Mounting from the rear side with bolts • A 10 pm filter in pressure line is requested • Use oil HM32 ISO 3448 VNK-T2 standard version ■ mounting for bar guides standard ■ bar guides not included VNK-T2-PXP for linear positioning system ■ mounting for bar guides standard ■ bar guides not included ■ Minikit PXP must be ordered separately ■ Sensor PXP 0 30mm not included VNK-T2-LPS-X for linear positioning system LPS-X ■ bar guides not included ■ Minikit LPS-X must be ordered separately ■ Sensor LPS-X not included see page 275 Ordering example VNK-T2 150-67-PXP • Cylinder Id. No. 77091916 • Minikit PXP Id. No. 60367941*** • Cylinder Id. No. 77091916 • Minikit LPS-X Id. No. 60367741*** Technical data SMW-AUTOBLOK Type VNK-T2 * Total at 30 bar / 50 °C ** At max. speed/ oil HM32 ISO 3448 *** Sensor non included in minikit Important: On higher pressure the leakage increases proportionally. On higher oil temperature the leakage increases over proportionally (the use of an oil cooler is recommended). When designing/checking the hydraulic unit please ask for our data sheets.

Open the catalog to page 1

Open center rotating hydraulic cylinder i up to 45 bar i THROUGH-HOLE 0 37.5 - 127.5 mm i short design/low mass stroke control via proximity switch or linear positioning system * Drain plug for leak oil can be installed on the right or left side as well. Subject to technical changes. For more detailed information please ask for customer drawing.

Open the catalog to page 2

Kits for VNK-T2 cylinders (optional) Open center ■ Kit CP3 for rotary union rotating hydraulic cylinder ■ Kit adjusting workstop Kit CP3 for VNK-T2 standard 1 medium rotary union Kit CP3 for VNK-T2-PXP/VNK-T2-LPS 1 medium rotary union Kit CP3 for VNK-T2 standard 2 media rotary union Kit CP3 for VNK-T2-PXP/VNK-T2-LPS 2 media rotary union Kit adjustable workstop (only for cylinders with Kit CP3 mounted) Important: The basis to mount the axial workstop is a VNK-T2 cylinder with the CP-3 standard unit mounted. The spindle of the work stop can have a through hole for media as an option.

Open the catalog to page 3