PRESSURE PRIME™ Non-Clog Non-Clog Pumps Pump LogixTM P-Series – a New Generation in Pump Control The PumpLogix™ P-Series controller is an intuitive pump controller; it is versatile and can be used as an intelligent Remote Terminal Unit (RTU) and a competent member of your SCADA (Supervisory Control and Data Acquisition) system. MODBUS® protocol is standard. PumpLogix™ P-Series I/O Retrofit Features The controller has an optional on-board audible alarm and an external alarm driver that activate on High and Low Level Alarm or Transducer Failure Alarm (i.e., input out of range). The PumpLogix ™ P-Series interface allows the operator to easily set the alternation order to Sequential, 1st On/1st Off, or Lead Pump Selectable. Manual level simulation allows the operator to test the controller’s operation and conf irm the configuration. Also the controller always indicates actual wet well level while in simulation mode. • Two External Inputs: Alarm Acknowledge and Control Inhibit For an interactive PX-2 demonstration, visit: www.smithandloveless.com/pumplogix • Three Isolated, Individually Fused Solid-State Triac Outputs Capable of Switching 1.5 Amps @ 120 VAC (Pump Required and Common Alarm) The PumpLogix™ P-Series controller is ideal for sewage lift stations or water systems applications. • Two DC/FET Outputs: System Monitor and External Audible Alarm Online: smithandloveless.com • Phone: Available in 10’, 20’ and 40’ operating range. Bulletin No. 680 ©2006, 2008 Smith & Loveless Inc. A Feature-Packed System Whether dealing with a new installation or retrof itting an existing panel, the PumpLogix ™ controller provides outstanding control, alarm and telemetry. Smith & Loveless Inc. System Innovators for global p umping, water and wastewater treatment

New PumpLogixTM P-Series Pump Controller Offers Pinpoint Control The PumpLogix™ P-Series controller by Smith & Loveless Inc. is an easy-to-see and easy-to-set automatic pump control and alarm monitoring system. The PumpLogix™ P-Series interface makes operation a simple process. The graphical display shows the wet well level, pump on/off setpoints and the high and low alarm setpoints. It’s as simple as turn, select, turn, set. That’s all it takes to move a pump control or alarm setpoint and change the current value. Easy to See All adjustments, including controller configuration, pump on/off settings...