In-line Type Vacuum Ejector Actual size Overall length Additional nozzle sizes added: 0.3 mm and 0.4 mm Additional inch size added: Ø 5/32" Application Examples For preventing pad adsorption failures from the vacuum source For improving responsiveness by installing on flexible parts Numerous pads can be used to adsorb workpieces with holes. Can be used to open and close plastic bags For mounting on the end of a Z-axis air cylinder Variations Model Standard supply Ultimate vacuum pressure [kPa] Maximum suction flow rate [L/min (ANR)] Air consumption Port size pressure [MPa] [l/min (ANR)] Type S Type L Type S Type L –85 1.8 3.4 4.2 Ø 4 One-touch fitting 0.35 –40 Ø 5/32" –87 3.2 5.8 7.7 7 13 14 Ø 6 One-touch fitting 0.45 –90 –48 Rc1/8 11 16 28

In-line Type Vacuum Ejector ZU첸A Series How to Order Port size Port size ZU03/04 ZU05/07 Ø 4 One-touch fitting — 앬 Ø 6 One-touch fitting — 앬 Rc1/8 female thread — 앬 Ø 5/32" — 앬 Ultimate vacuum pressure Symbol Specifications Operating temperature range Fluid Applicable tubing material Operating pressure range ZU03/04 Standard supply pressure ZU05/07 Ultimate vacuum pressure −85 kPa (ZU03)/−87 kPa (ZU04) −90 kPa −40 kPa −48 kPa -5 to 50 °C (No freezing) Air FEP, PFA, Nylon, Soft nylon, Polyurethane 0.1 to 0.6 MPa 0.35 MPa 0.45 MPa Ultimate vacuum pressure∗2 Maximum suction flow rate∗2 Weight Nozzle...

In-line Type Vacuum Ejector Exhaust Characteristics/Flow Rate Characteristics (Representative Value) ZU03LA Flow Rate Characteristics (0.35 MPa) 4 Suction flow rate 6 Suction flow rate Suction flow rate [l/min (ANR)] Exhaust Characteristics Flow Rate Characteristics (0.35 MPa) Suction flow rate 6 Suction flow rate [l/min (ANR)] Suction flow rate [l/min (ANR)] ZU05LA Flow Rate Characteristics (0.45 MPa) 25 Suction flow rate 15 Suction flow rate Air consumption Flow Rate Characteristics (0.45 MPa) Vacuum pressure Air consumption [l/min (ANR)] Suction flow rate [l/min (ANR)] Exhaust Characteristics...

One-touch Connection Screw-in Connection Specific Product Precautions Be sure to read this before handling the products. Refer to the back cover for safety instructions. For vacuum equipment precautions, refer to the “Handling Precautions for SMC Products” and the “Operation Manual” on the SMC website: https://www.smc.eu Model Selection Caution 1. When the product is mounted in between piping, the piping on both the P port side and the V port side should be adequately supported in order to avoid any unnecessary load from the piping being applied to the product. Failure to do so may lead to performance...

Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of “Caution,” “Warning” or “Danger.” They are all important notes for safety and must be followed in addition to International Standards (ISO/IEC)∗1), and other safety regulations. Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious...