3 Port Solenoid Valve Series Selectable power consumption! Low wattage specification added ∗ VP300/500 Power consumption 0.35 W (Without light) 0.4 W (With light) [With power saving circuit] [Starting 1.55 W, Holding 0.55 W] ∗ Conventional model: 2.0 W With DC light Power consumption is reduced by power saving circuit. Built-in full-wave rectifier (AC) Power consumption is decreased by approx. 1/3 by reducing the wattage required to hold the valve in an energized state.(Effective energizing time is over 40 ms at 24 VDC.) Refer to electrical power waveform as shown below. Electrical power waveform of energy saving type Applied voltage Noise is considerably reduced by changing it to DC mode with a full-wave rectifier. apparent power Conventional 5.6 VA → 1.55 VA [Standard] Longer life expectancy: 50 million cycles or more (Conventional: 20 million cycles) ∗ Based on SMC test conditions. Energy saving strainer in the pilot valve Unexpected troubles due to foreign matter can be prevented. Rubber material: HNBR Note) Be sure to mount an air filter on the inlet side. With power saving circuit Ozone-resistant specification ∗ The pilot valve poppet is made of FKM.
Open the catalog to page 1Model Selection by Operating Conditions q Solenoid Valve: Single Unit Series Port size Electrical entry Light/surge voltage suppressor Manual override Body ported L-type plug connector Non-locking push type M-type plug connector External pilot N.C./N.O. Solenoid valve Base mounted With surge voltage suppressor With light/surge voltage suppressor With surge voltage suppressor (Non-polar) With light/surge voltage suppressor (Non-polar) Push-turn locking slotted type With light/surge voltage suppressor DIN (EN1753 01-803) terminal Conduit terminal Push-turn locking lever type Power consumption:...
Open the catalog to page 2Model Selection by Operating Conditions w Solenoid Valve: Manifold Series Applicable stations Note) Manifold base model Base mounted Solenoid valve Note) Supply pressure to 1(P) ports and exhaust air from 3(R) ports on both sides for 10 stations or more.
Open the catalog to page 3Rubber Seal 3 Port/Pilot Poppet Type Body Ported/Single Unit Series VP300/500/700 Note) Only DIN and conduit terminal types are available for AC mode. Refer to the electrical entry for details. Body ported Series 3 5 7 Pilot type Thread type Internal pilot External pilot Standard (0.7 MPa) High-pressure type (1.0 MPa) Without bracket With bracket Standard With power saving circuit (DC only) Note) Be sure to select the power saving circuit type when it is continuously energized for a long time. (Refer to page 1861 for details.) ∗ T type is only available for DC mode. When T is selected, only Z...
Open the catalog to page 4Pilot Poppet Type Body Ported/Single Unit Low power consumption 1.5 W (DC) Possible to use as either a selector or divider valve Possible to change from N.C. to N.O. • Refer to page 1862 for changing the type of actuation. Possible to use in vacuum applications Up to –100 kPa Specifications Fluid Type of actuation Standard Internal pilot Operating pressure range (MPa) High-pressure type Standard External pilot High-pressure type Operating pressure range (MPa) Pilot pressure range Ambient and fluid temperature (°C) Max. operating frequency (Hz) Manual override Pilot exhaust type Lubrication Mounting...
Open the catalog to page 5Series VP300/500/700 Flow Characteristics/Weight Model Port size Note) Values without bracket Application Example (1) Blow-off valve (2) Pressure release valve External pilot External pilot (7) Double-acting cylinder drive (8) Double-acting cylinder drive (Exhaust center) N.O. (R)3 Vacuum releasing air Atmospheric pressure External pilot or micro pressure (6) Single-acting cylinder drive External pilot Construction Body ported Symbol Pilot type Bracket Assembly Part No. Aluminum die-casted Adapter plate Piston Poppet valve Description Bracket (With 2 screws) Aluminum/HNBR Resin Stainless steel...
Open the catalog to page 6Pilot Poppet Type Body Ported/Single Unit How to Order Pilot Valve Assembly Caution When only the pilot valve assembly is replaced, it is not possible to change from V211 (Grommet or L/M-type) to V212 (DIN or Conduit type), or vice versa. Valve model: ∗ Select from the below in accordance with the valve used. 5 G Z Light/surge voltage suppressor Nil Without light/surge voltage suppressor With surge voltage suppressor With light/surge voltage suppressor With surge voltage suppressor (Non-polar) With light/surge voltage suppressor (Non-polar) V211 Pilot valve assembly Note) There is no S option...
Open the catalog to page 7Series VP300/500/700 Series VP300/Body Ported/Dimensions Grommet (G) 1/8, 1/4 2(A) port M5 x 0.8 External pilot port (External pilot specification: R) Manual override 20.4 16 57.6 Approx. 300 (Lead wire length) (Indicator light) e betw een p orts) 1/8, 1/4 1(P), 3(R) port Approx. 300 (Lead wire length) DC without light/surge voltage suppressor (Mounting groove for M5 thread) ∗ Refer to page 1857 separately when piping to PE port is required. Approx. 300 (Lead wire length) M-type plug connector (M) Approx. 300 (Lead wire length) L-type plug connector (L) (Indicator light) [ ]: Without indicator...
Open the catalog to page 8Pilot Poppet Type Body Ported/Single Unit Series VP500/Body Ported/Dimensions Grommet (G) 1/4, 3/8 2(A) port 1/8 External pilot port (External pilot specification: R) Approx. 300 (Lead wire length) Manual override (Indicator light) DC without light/surge voltage suppressor Approx. 300 (Lead wire length) (Mounting groove for M5 thread) etwee n port s) 1/4, 3/8 1(P), 3(R) port 123.5 ∗ Refer to page 1857 separately when piping to PE port is required. Approx. 300 (Lead wire length) DIN terminal (D, Y) Applicable cable O.D. ø4.5 to ø7 M-type plug connector (M) Approx. 300 (Lead wire length) L-type...
Open the catalog to page 9Series VP300/500/700 Series VP700/Body Ported/Dimensions Grommet (G) 1/8 External pilot port (External pilot specification: R) 106.8 Approx. 300 (Lead wire length) (Mounting groove for M6 thread) Approx. 300 (Lead wire length) (Indicator light) DC without light/surge voltage suppressor 107.5 ∗ Refer to page 1857 separately when piping to PE port is required. Approx. 300 (Lead wire length) M-type plug connector (M) Approx. 300 (Lead wire length) L-type plug connector (L) (Indicator light) [ ]: Without indicator light Unless otherwise indicated, dimensions are the same as Grommet (G).
Open the catalog to page 1099 Pages
117 Pages
36 Pages
12 Pages
24 Pages
18 Pages
12 Pages
19 Pages
63 Pages
79 Pages
268 Pages
2 Pages
2 Pages
5 Pages
6 Pages
5 Pages
3 Pages
52 Pages
124 Pages
23 Pages
29 Pages
12 Pages
11 Pages
32 Pages
59 Pages
10 Pages
41 Pages
62 Pages
111 Pages
59 Pages
127 Pages
9 Pages
41 Pages
3 Pages
9 Pages
4 Pages
2 Pages
24 Pages
23 Pages
16 Pages
28 Pages
56 Pages
7 Pages
32 Pages
7 Pages
12 Pages
28 Pages
4 Pages
12 Pages
60 Pages
2 Pages
2 Pages
13 Pages
69 Pages
14 Pages
13 Pages
32 Pages
68 Pages
44 Pages
117 Pages
23 Pages
44 Pages
30 Pages
51 Pages
20 Pages
65 Pages
7 Pages
36 Pages
18 Pages
56 Pages
20 Pages
15 Pages
14 Pages
51 Pages
84 Pages
6 Pages
246 Pages
18 Pages
14 Pages
19 Pages
95 Pages
4 Pages
3 Pages
24 Pages
35 Pages
5 Pages
62 Pages
78 Pages
60 Pages
62 Pages