5 Port Solenoid Valve i seal )[ Rubber seal) Connector Type Manifold Power saving (Reduced by 60% compared to existing model)

Connector Type Manifold Series VQC1000/2000 Power saving IP67 enclosure compatible Dust-tight, Immersion-proof Standard: W (Reduced by % compared to existing model) High-pressure (1 MPa, Metal seal): W Accommodates gateway-type serial wiring. Gateway unit types include DeviceNet™, PROFIBUS DP, and EtherNet/IP™. Because just one gateway unit controls up to 4 branch lines, it offers much more freedom in choosing valve mounting locations in comparison with other serial units. Manifolds and input blocks can be mounted near the actuator, allowing for use of short air piping or electric wiring. The...

Compact and high flow Flow-rate characteristics Note) Metal seal Rubber seal C [dm3/(s·bar)] b Cv C [dm3/(s·bar)] b Applicable cylinder bore size (mm) Note) Flow-rate characteristics: 2-position single, 4/2 → 5/3 (A/B → R1/R2) Connector entry direction can be changed with a single push. (F/P kit) The connector entry direction can be changed from the top to the side by simply pressing the manual release button. It is not necessary to use the manual release button when switching from the side to the top. A wide variety of prepackaged wiring configurations S kit (Flat ribbon cable) Our six standard...

Series VQC/Base Sonic conductance C [dm3/(s·bar)] Applicable cylinder bore size Serial transmission Gateway application Compatible network Compatible network • DeviceNet™ • DeviceNet™ • PROFIBUS DP • PROFIBUS DP • EtherNet/IP™ • CC-Link Decentralized • EtherNet/IP™ Serial Wiring • EtherCAT Gateway application • PROFINET requires a gateway unit and communication cable separately. Please contact SMC for details. Compatible network Compatible network • DeviceNet™ • PROFIBUS DP • CC-Link • AS-Interface • CANopen • EtherNet/IP™ • DeviceNet™ • CC-Link • PROFIBUS DP Output • CC-Link • EtherCAT • PROFINET...

5 Port Solenoid Valve D-sub connector Flat ribbon cable Terminal block box Electrical entry D-sub connector Conforming to MIL D-sub connector Flat ribbon cable Conforming to MIL flat ribbon cable connector (Terminal block) Terminal block is compactly arranged on one side. Lead wire IP67 enclosure with use of multiple wire cable with sheath and waterproof connector Port size Circular connector Circular connector IP67 enclosure with use of waterproof circular connector Cylinder port 26 pins 25-core cable 25 pins

Cylinder Speed Chart This chart is provided as guidelines only. For performance under various conditions, use SMC's Model Selection Program before making a judgment. Bore size Series CJ2 Pressure 0.5 MPa Load factor 50% Stroke 60 mm ø6 Series MB, CA2 Pressure 0.5 MPa Load factor 50% Stroke 500 mm ø40 Series CM2 Pressure 0.5 MPa Load factor 50% Stroke 300 mm Perpendicular, upward actuation Horizontal actuation ∗ It is when the cylinder is extending that is meter-out controlled by speed controller which is directly connected with cylinder, and its needle valve with being fully open. ∗ The average...

VQC1000/2000 Model, Standard/Manifold Specifications. .. P. 1172 0kit (Serial transmission [Fieldbus system]) EX600 0 kit (Serial transmission) EX250 p -j-jgo Q kit (Flat ribbon cable) p -|-|gg

Base Mounted Plug-in Unit Series VQC1000 How to Order Manifold Base mounted plug-in Enter EX600-compliant S kit only. ······ Stations 01 The maximum number of stations differs depending on the electrical entry. (Refer to Kit type/Electrical entry/Cable length.) Note) In case of compatibility with the S kit/AS-Interface, the maximum number of solenoids is as shown below, so please be careful of the number of stations. • 8 in/8 out: Maximum 8 solenoids • 4 in/4 out: Maximum 4 solenoids Cylinder port size ····· Enter EX250-compliant S kit only. Input block specification PNP sensor input (Positive...

Base Mounted Plug-in Unit SJ ∗ Numbers in parentheses represent the maximum number of solenoids in case of mixed single and double wiring. The maximum number of stations is determined by the total number of solenoids. When ordering mixed wiring, please add the option symbol “-K”. Kit type/Electrical entry/Cable length (Serial transmission: EX500 gateway-type) (Serial transmission (Fieldbus system): EX600 integrated-type (I/O)) Note) A separate gateway unit and communication cable are required. (Serial transmission: EX260 integrated-type (for output)) Without SI unit DeviceNet™ PROFIBUS DP CC-Link...

Series VQC1000 SI Unit Part No. EX500 Symbol Positive common (NPN) Negative common (PNP) Positive common (NPN) Negative common (PNP) AS-Interface, 4 in/4 out, 31 slave modes, EX250-SAS5 2 power supply systems AS-Interface, 8 in/8 out, 31 slave modes, EX250-SAS7 1 power supply systems AS-Interface, 4 in/4 out, 31 slave modes, EX250-SAS9 1 power supply systems SDY CANopen SDZEN EtherNet/IP™ Number SI unit part no. Communication of connector outputs Positive common (NPN) Negative common (PNP) EtherCAT PROFINET EtherNet/IP™ Note) When the communication connector specification is D-sub, the enclosure...

Plug-in Unit Base Mounted Note) Rubber seal only Nil: Non-locking push type (Tool required) A Standard (0.4 W) High-speed response type (0.95 W) High-pressure type (1.0 MPa, 0.95 W) Negative common External pilot C: Locking type (Manual) VQ5 D: Slide locking type Light/surge voltage suppressor Note) Only 24 VDC is available with the S kit. (Tool required) Coil voltage Note 1) When two or more symbols are specified, indicate them alphabetically. However, combination of “B” and “K” is not possible. Note 2) Metal seal only Note 3) When “-COM.” is specified for the SI unit, select and mount the valve...