0.15 W (SJ3000 with power saving circuit)0.23 W (SJ2000 with power saving circuit) (Based on SMC life test conditions) New Can easily increase or decrease stations and replace valves.Օ34 pins connector allows up to 16 stations with double solenoids, 32 stations with single solenoids. D-sub connector Piping variations With switch Manual locking > With one-touch fittingsThreaded type Possible to shut the signal of each valves individually.ՕManual operation is possible by switching OFF, even when the valve is in the energ- ized state. Prevents wrong operation by sliding the switch to avoid a manual...

ProgrammableLogic Controller Serial Transmission Input unit Input unit Including SI unitmanifold valve Including SI unitmanifold valve Input unit Input unitOutput unit Including SI unitmanifold valve >

SOL.a SOL.a SOL.a SOL.a (14) (14) (14) (14) > SOL.bSOL.a SOL.a SOL.b SOL.bSOL.a SOL.a SOL.b COM COM SOL.aSOL.bSOL.bSOL.a > Station3Station4 SOL.aSOL.bSOL.bSOL.a > Station1Station2

Slotted locking type Manual Plug-in > Connector connection PS port: Pressure detection port(M5 x 0.8) Eliminates foreign matter on vacuum and release side.ՕReplaceable 2(B)Vacuum pad port 1(P)Release pressure port3/5(E)Vacuum pressure port Flow rate adjustment of release airՕPrevents workpiece blow-off. Wiring variations > D-sub connector ՕFlat ribbon cablePC wiring ՕSerial (EX180)Serial (EX510) Non-plug-in > ՕIndividual wiring Power consumption 0.15W (with power saving circuit) Adsorbing and Transferring System Circuit Example Width: 10 mm (same size as SJ3000 series) > (Ejector)Vacuum pumpVacuum...

(B)2SOL.aSOL.b(A)4 (B)2 SOL.a SOL.b 5(EA)1(P)3(EB) 5(EA)1(P)3(EB) Resin/H-NBRResin/H-NBRZinc die-castResin ResinResinResinResin Resin > 5(EA)/3(EB)1(P) 12345 678910 Spool valve assemblySpool valve assembly N.C. (Normally closed) N.O. (Normally open) > Body Adaptor plate Pilot adaptor חWhiteWhiteWhiteWhiteWhiteLight blueSJ2000-CL-1 (10 pcs.) Pilot valve assembly Body cover Port block Bottom cover Light cover > DescriptionNo.Part no. 1112 One-touch fitting Clip Refer to the one-touch fitting part no.on back page 6. >

P.10 > D-sub Connector / Flat Ribbon Cable / PC Wiring P.26 > PC Wiring System with Power Supply Terminal P.34 > Serial Wiring: EX180 Gateway SystemSerial Transmission System: EX510 P.42 > 9 size="-2">

Note) Refer to pages 52 and 53 for the dedicated non-plug-in individual wiring. ∗ There is no need to enter anything for 2 position double, 3 position and 4 position solenoid valves.Select this when the unused numbers to wiring are set. Refer to page 3 for details. ∗ Back pressure check valve is not applica- ble for 3 position valve. ∗ External pilot spec. is not applicable for 4 position dual 3 port valves. ∗ Be sure to select with power saving circuitӔ when the solenoid valve will be energized continuously for long period. :踸6one-touch fitting(SJ3000 only)(Inch size) > ∗ Refer to pages 4 through...

(Connector entry direction upward) Valve lock switch (8) Applicable connector: D-sub {JIS-X-5101, MIL-C-24308} equivalent > 5.5 FREELOCK PE 56.217.520.8 35 X DIN rail > BA Silencer (Air discharge port) (Built-in silencer spec.) 4(A) port side: Blue2(B) port side: YellowManual override(Locking type: Press, then rotate.) Switch for locking a connector Terminal no. 1DIN rail holding screw(DIN rail mounting hole pitch: 12.5) 30.6 > (Forindividualwiring) Approx.3005.3 (17.1)(9.1) (8.6)(1.8) (Whenequippedwithswitch) (Leadwirelength) Manual override switch (Station n)(Station 1) 5.9 > OFF OFF 40 (45.9)32.17.5...

(Pitch)P=7.5 One-touch fitting[4(A), 2(B) port]Applicable tubing O.D: 2, 1/8"踸4, 5/32"M3x0.5[4(A), 2(B) port]One-touch fitting[1(P), 3/5(E) port]Applicable tubing O.D: 8, 踸5/16" [External pilot spec.] 11.5 34.323.6 (There is a piping of X, PE port in the both sides.) > 3/5 24 24D 24D 2442243/513/51 30.6 32.515 15.6 1 54.546.258.219.3(16.3)10(7) D 24 One-touch fitting(PE: Pilot EXH port)Applicable tubing O.D: 4, 5/32"One-touch fitting(X: External pilot port)Applicable tubing O.D: 踸4, 5/32"(Connector entry direction upward)Applicable connector: D-sub {JIS-X-5101, MIL-C-24308} equivalent (When equipped...

(Pitch)P=10 One-touch fitting[4(A), 2(B) port]Applicable tubing O.D: 2, 1/8" 踸4, 5/32"6, 踸1/4"M5 x 0.8[4(A), 2(B) port]One-touch fitting[1(P), 3/5(E) port]Applicable tubing O.D: 8, 5/16" 23.6 12.8 [External pilot spec.] > 3/5 24D 24 24243/5124D 24D42 31 32.115.4 15.6 1 54.558.246.219.3(16.3)10(7) One-touch fitting(PE: Pilot EXH port)Applicable tubing O.D: 踸4, 5/32"One-touch fitting(X: External pilot port)Applicable tubing O.D: 4, 踸5/32"(Connector entry direction upward)Applicable connector: D-sub {JIS-X-5101, MIL-C-24308} equivalent 20.56.2 5 Switch for locking a connectorValve lock switch Uside...

(Pitch)P=1012.834.323.6 [External pilot spec.] (There is a piping of X, PE port in the both sides.) (Built-in silencer spec.)Silencer (Air discharge port) DIN rail SOL.a: OrangeSOL.b: GreenLight/surge voltage suppressor(DIN rail mounting hole pitch: 12.5) > 3/5 24D 24 30.6 32.115.4 15.6 1 42242424D 24D 3/513/51 54.558.246.219.3(16.3)10(7) 9.9 M5x0.8[4(A), 2(B) port]One-touch fitting[1(P), 3/5(E) port]Applicable tubing O.D: 8, 5/16" One-touch fitting(PE: Pilot EXH port)Applicable tubing O.D: 踸4, 5/32"One-touch fitting(X: External pilot port)Applicable tubing O.D: 4, 踸5/32" 20.56.2 8 5 Switch for...

(Pitch)P=7.511.5 23.6 [External pilot spec.] > 3/5 24 24D 24D 2442243/51 30.6 32.515 15.6 1 54.558.246.219.3(16.3)10(7) D 24 One-touch fitting[4(A), 2(B) port]Applicable tubing O.D: 2, 1/8"踸4, 5/32"M3 x 0.5[4(A), 2(B) port]One-touch fitting[1(P), 3/5(E) port]Applicable tubing O.D: 8, 踸5/16" One-touch fitting(PE: Pilot EXH port)Applicable tubing O.D: 4, 5/32"One-touch fitting(X: External pilot port)Applicable tubing O.D: 踸4, 5/32"(Connector entry direction upward) Switch for locking a connectorValve lock switch Uside Dside > Applicable connector: 26 pin MIL type (8)6.220.5 8 with strain relief...