For details about certified products conforming to international standards, visit us at www.smcworld.com. Pneumatic Pressure Switch Series IS3000 Model Can be used for micro load, around 10 mA e.g. relays, programmable controllers, etc. Micro switch type Micro load Piping method Rc 1/4 thread Gasket piping Rc 1/4 thread Gasket piping Easy electrical wiring Wide space for wiring. Fixed wiring possible with G 1/2 connector. Calibration range 0.1 to 0.7 MPa Frequency: 1 cycle/sec Service life: 10 million cycles With indicator light Specifications Air/Inert gas 1.0 MPa 0.8 MPa 0.1 to 0.7 MPa –5 to 60°C (No freezing) 1ab ±0.1 MPa 0.05 MPa or less ±0.05 MPa Equivalent to IP40 0.15 kg Fluid Proof pressure Max. operating pressure Pressure adjustment range Ambient and fluid temperature Contacts Error of scale Hysteresis Repeatability Enclosure Mass Micro Switch Ratings IS3100 (Gasket piping) Non inductive (A) Load resistance Light load Load Circuit Rated voltage (V) 125 AC 250 AC 30 DC 125 DC IS3110 (Gasket piping) Inductive load (A) Inductive load Motor load N.C. IS3 0 10 1 Non inductive (A) Load resistance N.C. Insulation resistance: 100 MΩ or more at 500 VDC by megameter Voltage resistance: 1500 VAC, 50/60 Hz for 1 min. (When using switch with neon light: 1000 VAC for 1 min.) L1 Pressure display with scale plate Rc 1/4 thread Gasket piping Micro switch load type 0 1 Port size Indicator light Standard Micro load Nil 02 N02 With gasket None With neon light/110 VAC With neon light/220 VAC LED/24 VDC Note) Micro load type: Not available “L2” option.

Pneumatic Pressure Switch Be sure to read before handling. Refer to front matters 58 and 59 for Safety Instructions and pages 687 to 691 for Pressure Switch Precautions. 1. Since the light emitting diode (LED) is used for the light assembly for 24 VDC, there are 2 terminals and polarity. One is “+” for red load wire and the other is “–” for black load wire. Light will not light up if wired incorrectly. 2. Light ass'y for 24 VDC has 3 mA of current leakage. Connect the LED directly to the power supply if the input of the PLC sees the switch as closed at all times due to leakage. Ex. 1) When using...