New Pressure Switch/Reed Switch Type ˾ 16% lighter 11% smaller Weight: 62 g Overall height: 52 mm ∗Previous type 74 g Pressure switch Compared with IS1000 (Made by SMC) Compared with IS1000 (Made by SMC) 0.1 to 0.4 MPa Service life: 5 million cycles 15 m m mm Pressure switch Pressure switch with spacer with piping adapter Electrical Circuit Up to 100 V AC/DC Proof pressure Ambient and fluid temperature Grommet, Lead wire length: 0.5 m Option: 3 m, 5 m Port size Wiring specifications Can be connected to Modular type F.R.L. units. Switch Characteristics Max. contact capacity Voltage AC/DC Max. operating current and range Thread type None With seal Lead wire length Semi-standard: Select one option each in a through c. Place them in alphanumerical order. Example) IS10-N01-6PZ Note 1) Set pressure range of 6P(L, Z) is 0.2 to 0.6 MPa (30 to 90 psi). Note 2) This product is for overseas use only according to the new Measurement Law. (The SI unit type is provided for use in Japan.) Scale plate MPa Nil pressure unit P Note2) Both MPa and psi

Component Parts Switch assembly Shield plate Steel sheet Steel sheet Adjusting screw 1. Connect load before connecting with power source. The switch will break instantly if no load is connected. 2. Make the wiring length as short as possible. When the load which is operated by the pressure switch is an inductive load, or the lead wire is 5 m or longer, use the contact protection box shown in the table below. Otherwise, damage to the switch can result. Part no. Lead wire length 100 V AC Switch side: 0.5 m 24 V DC Load side: 0.5 m 1. When handling the product, hold the body and do not apply tensile...

Pressure Switch Reed Switch Type Pressure Switch for Connecting to Modular/F.R.L. Units Pressure Switch with Spacer 15 Pressure switch Semi-standard: Select one option each in a through c. Place them in alphanumerical order. Example) IS10M-6LP Symbol Description Body size Lead wire length MPa Ȝ Ȝ Ȝ Ȝ Ȝ Nil Scale plate pressure unit P Note 2) Both MPa and psi Ȝ Ȝ Ȝ Ȝ Ȝ Note 1) Set pressure range of 6P(L, Z) is 0.2 to 0.6 MPa (30 to 90 psi). Note 2) This product is for overseas use only according to the new Measurement Law. (The SI unit type is provided for use in Japan.) Applicable model Note)...

Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage. These instructions indicate the level of potential hazard with the labels of “Caution,” “Warning” or “Danger.” They are all important notes for safety and must be followed in addition to International Standards (ISO/IEC)∗1), and other safety regulations. Caution indicates a hazard with a low level of risk which, if not avoided, could result in minor or moderate injury. Warning indicates a hazard with a medium level of risk which, if not avoided, could result in death or serious...