*mydirectindustry

Catalogs
smartGAS Mikrosensorik GmbH
Carbon monoxide CO 100 Vol.-%

Carbon monoxide CO 100 Vol.-%

Product catalog summary

Product Overview
The FLOWEVO Infrared Gas Sensor for Carbon Monoxide (CO) by smartGAS Mikrosensorik GmbH is a pre-calibrated, compact device designed for various applications including gas analysis, biogas applications, environmental monitoring, process control, and emission monitoring. It features a 3/5 mm gas line connector and operates on a 3.3–6 V DC supply voltage with Modbus ASCII or RTU communication.

Specifications

Measurement Principle: Non-Dispersive Infra-Red (NDIR), dual wavelength
Measurement Range: 0 to 100 Vol.-% Full Scale (FS)
Flow Rate: 0.1 to 1.0 l/min
Mounting Dimensions: 76 mm x 30 mm x 50 mm
Warm-up Time: Less than 2 minutes for start-up, less than 30 minutes for full specification

Measuring Response

Digital Resolution: 0.01 Vol.-%
Response Time: t90 ≤ 9.9 s, ton ≤ 16.5 s at 0.7 l/min
Detection Limit: ≤ 0.2 Vol.-%
Repeatability: ≤ ± 0.6 Vol.-%
Linearity Error: ≤ ± 0.9 Vol.-%
Long Term Stability: Zero ≤ ± 0.45 Vol.-% over 1000 hours, Span ≤ ± 1.98 Vol.-% over 1000 hours

Environmental and Electrical Parameters

Operating Temperature: 0 to +50 °C
Storage Temperature: -20 to +60 °C
Air Pressure: 800 to 1150 hPa
Humidity: 0 to 95% relative humidity (non-condensing)
Supply Voltage: 3.3 V to 6.0 VDC
Power Consumption: Average < 800 mW

Additional Information
The sensor requires a stable, particle-free, and clean sample gas with a dew point of less than +5°C. Calibration is recommended at first initiation and periodically thereafter. The device is made in Germany and all specifications are subject to change without notice. For further details, visit the smartGAS website or contact their sales team.

Catalog excerpts

FLOWEVO Infrared gas Sensor Carbon monoxide CO 100 Vol.-% smartGAS item number: F3-222108-05000 Pre calibrated Compact Design 3/5 mm gas line connector 3.3–6 V DC supply voltage Modbus ASCII or RTU Status indicated by LED Low drift Application examples Gas analysis Biogas application Environmental monitoring Process control Emission monitoring Available equipment Gas cooler Particle filter Gas pump Calibration Software Mounting equipment smartGAS Mikrosensorik GmbH I Huenderstr. 1 I 74080 Heilbronn I Germany T +49 7131 797553-0 I F +49 7131 797553-10 I [email protected] I www.smartgas.eu Available design in support Mechanical Installation Data communication Gas pre-treatment

Open the catalog to page 1

FLOWEVO I Carbon monoxide CO I F3-222108-05000 General features Measurement principle: Non-Dispersive Infra-Red (NDIR), dual wavelength Measurement range: by flow (nearly atmospheric pressure) Flow rate: Mounting dimensions: Warm-up time: < 2 minutes (start-up time) < 30 minutes (full specification) Measuring response* Digital resolution: Linearity error (straight line deviation): Long term stability (zero): Long term stability (span): Influence of T, P, flow rate, other* Temp. dependence (zero): Temp. dependence (span): Pressure dependence: Flow rate dependence: Cross sensitivity (zero) other...

Open the catalog to page 2

Carbon monoxide CO 100 Vol.-%

Carbon monoxide CO 100 Vol.-%

Catalog excerpts

All SmartGAS Mikrosensorik GmbH catalogs and technical brochures