*mydirectindustry

Catalogs
smartGAS Mikrosensorik GmbH
Carbon dioxide CO2 5000 ppm

Carbon dioxide CO2 5000 ppm

Product catalog summary

Product Overview: The FLOWEVO Infrared Gas Sensor is designed for detecting carbon dioxide (CO2) with a measurement range of 0 to 5000 ppm. It features a compact design, pre-calibration, and supports Modbus ASCII or RTU communication. The sensor is suitable for applications such as gas analysis, biogas applications, and environmental monitoring.

Specifications: The sensor operates on the Non-Dispersive Infra-Red (NDIR) principle with dual wavelength. It requires a supply voltage of 3.3 to 6 V DC and has a digital resolution of 1 ppm. The response time varies with flow rate, with a standard t90 response time of ≤ 9.9 seconds at 0.7 l/min.

Performance: The sensor exhibits low drift and high repeatability with a detection limit of ≤ 20 ppm. It maintains long-term stability with zero drift ≤ ± 200 ppm and span drift ≤ ± 500 ppm over 1000 hours.

Environmental and Electrical Parameters: The sensor operates within a temperature range of 0 to +50 °C and can be stored between -20 to +60 °C. It functions under air pressure conditions of 800 to 1150 hPa and relative humidity of 0 to 95% (non-condensing). The average power consumption is < 800 mW.

Installation and Calibration: The sensor requires mechanical installation and gas pre-treatment. Calibration is performed via software for zero and span adjustments. Recalibration is recommended at initial setup and periodically based on application conditions.

Additional Information: The document emphasizes the importance of consulting smartGAS for specific applications and recalibration needs. It also notes that specifications are subject to change without notice and advises consulting the manufacturer for cross-sensitivity to other gases.

Catalog excerpts

FLOWEVO Infrared gas Sensor Carbon dioxide CO2 5000 ppm smartGAS item number: F3-212505-05000 Pre calibrated Compact Design 3/5 mm gas line connector 3.3–6 V DC supply voltage Modbus ASCII or RTU Status indicated by LED Low drift Application examples Gas analysis Biogas application Environmental monitoring Available equipment Gas cooler Particle filter Gas pump Calibration Software Mounting equipment smartGAS Mikrosensorik GmbH I Huenderstr. 1 I 74080 Heilbronn I Germany T +49 7131 797553-0 I F +49 7131 797553-10 I [email protected] I www.smartgas.eu Available design in support Mechanical Installation Data communication Gas pre-treatment

Open the catalog to page 1

FLOWEVO I Carbon dioxide CO2 I F3-212505-05000 General features Measurement principle: Non-Dispersive Infra-Red (NDIR), dual wavelength Measurement range: by flow (nearly atmospheric pressure) Flow rate: Mounting dimensions: Warm-up time: < 2 minutes (start-up time) < 30 minutes (full specification) Measuring response* Digital resolution: Linearity error (straight line deviation): Long term stability (zero): Long term stability (span): Influence of T, P, flow rate, other* Temp. dependence (zero): Temp. dependence (span): Pressure dependence: Flow rate dependence: Cross sensitivity (zero) other...

Open the catalog to page 2

Carbon dioxide CO2 5000 ppm

Carbon dioxide CO2 5000 ppm

Catalog excerpts

All SmartGAS Mikrosensorik GmbH catalogs and technical brochures