Catalogs >
Skynet Electronic >
SNP-Z05 Series

SNP-Z05 Series
4Pages

Catalog excerpts

Rated 55W Peak 65W SNP-Z05 Series General Purpose Only 1.1 inch height With ITE & Medical safety Operating from 0oC to 60oC by convection Mechanical Specifications: Dimensions shown in mm as left. Tolerance: + -0.4mm. Size: 101.6 X 50.8 X 28.5 (mm) 4" X 2" X 1.1" Packing: Net weight: 140 g approx. / unit Gross weight: 13.5 kg approx. / carton, 80 units / carton Carton size (mm): 382 (L) x 374 (W) x 277 (H) Connectors: AC input : JST B2P3-VH or equivalent DC output : JST B4P-VH or equivalent for single output JST B7P-VH or equivalent for multiple outputs Output Pin assignment: PIN NO. ** This data sheet is only for model selection. For business, engineering specification by model must be used.

Open the catalog to page 1

Rated 55W Peak 65W SNP-Z05 Series General Purpose Output Specifications: MODEL Note: 1. The max. load can be continuously provided at 40oC and convection cooling conditions. The peak load can be temporarily provided up to 8 seconds. 2. At factory, all outputs in 60% rated load condition, each output is checked to be within the accuracy range while the main output is setting to within the specified accuracy range at rated load. 3. Line regulation is defined by changing ±10% of input voltage from nominal line at rated load. 4. Load regulation is defined by changing ±40% of measured output...

Open the catalog to page 2

Rated 55W Peak 65W SNP-Z05 Series General Purpose Performance for SNP-Z057: 1. Switching frequency ripple 2. Line frequency ripple 4. Output turn off wave form 3. Output turn on wave form 6. Over voltage protection Trip point around 14.5V ** This data sheet is only for model selection. For business, engineering specification by model must be used.

Open the catalog to page 3

General Purpose 10. Power derating curve (SNP-Z056) Rated load Operating Temperature 11. Power derating curve (SNP-Z057/8/9/T) Rated load This data sheet is only for model selection. For business, engineering specification by model must be used.

Open the catalog to page 4