TIH L MB series Induction heaters for non-bearing applications The SKF TIH L MB series is specially designed to heat solid workpieces, such as rings, sleeves, gears, couplings, bushings and pulleys, as well as train wheels, tires or similar components. Featuring one magnetic coil in the center, these powerful and durable heaters localize the heating in the workpiece bore for superior performance on solid components. The TIH L MB series provides the following advantages for quick and effective heating of solid workpieces: • • • • • • • Simple and safe operation with remote-control and power level selection Superior heating performance for solid workpieces with low energy consumption Quick and easy placement of solid components with sliding yoke Automatic demagnetization reduces risk of ferrous debris contamination Easy to transport using standard forklift Available in three voltage variants to suit most operating voltages worldwide Available with three different operating areas The TIH L MB heats non-bearing workpieces up to 600 kg (1 323 lb), depending on the model. The TIH L MB induction heater is equipped with a remote control panel for operator safety. Advice: The SKF TIH L MB series heaters are designed for induction heating of solid, non-bearing components. For bearingheating applications, we recommend the use of equivalent SKF TIH L seri

Technical data Designation Maximum workpiece weight Bore diameter range Coil diameter Standard yokes (included) to suit workpiece minimum bore diameter Temperature control Time control 0–120 minutes; in steps of 0,1 minute 0–120 minutes; in steps of 0,1 minute 0–120 minutes; in steps of 0,1 minute Demagnetisation according to SKF norms Maximum heating temperature 2) Some special voltage versions (e.g. 575V, 60Hz CSA ready) are available for specific countries. For additional information, please contact your local SKF authorised distributor. Depending on bearing or workpiece weight. For higher...