TIH 030m Small induction heater with a 40 kg bearing heating capacity The new SKF small induction heater TIH 030m combines high heating capacity with portability. The compact lightweight design makes the TIH 030m portable. Placing the induction coil outside the heater’s housing allows the heating of bearings weighing up to 40 kg (88 lb). The heater is equipped with thermal overheating protection to reduce the risk of damage to the induction coil and the electronics. • Compact lightweight design; just 21 kg (46 lb), facilitating portability • Capable of heating a 28 kg (62 lb) bearing in just 20 minutes • Supplied standard with three yokes, allowing bearings with a bore diameter from 20 mm (0.8 in.) up to a maximum weight of 40 kg (90 lb) to be heated Features and benefits I nduction coil located outside the heater’s housing enables a shorter heating time and lower energy consumption Foldable bearing support arms allow larger diameter bearings to be heated, and reduce the risk of the bearing toppling during heating M agnetic temperature probe, combined with a temperature mode pre-set at 110 °C (230 °F), helps prevent bearing overheating U nique SKF remote control, with operating display and control panel, makes the heater easy and safe to use I nternal yoke storage, for smaller yoke(s), reduces the risk of yoke damage or loss I ntegrated carrying handles allow for easy movement of the heater in the

Technical data Designation Max. bearing weight Bore diameter range Operating area (w x h) Coil diameter Standard yokes (included) to suit bearing/workpiece minimum bore diameter Application example (bearing, weight, temperature, time) Max. power consumption Total weight (incl. yokes) 20,9 kg (46 lb) SKF induction heater ranged [mm] The comprehensive range of SKF induction heaters is suitable for most bearing heating applications. The chart gives general information on choosing an induction heater for bearing heating applications 3). The SKF m20 concept represents the weight (kg) of the heaviest...