Quick detection of oil condition changes SKF Oil Check Monitor TMEH 1 The SKF TMEH 1 measures the changes in dielectric constant of an oil sample. By comparing measurements obtained from used and fresh samples of the same oil, the degree of change in the condition of the oil is established. Dielectric change is directly related to the oil’s degradation and contamination level. The monitor allows tracking of mechanical wear and of any loss of the oil’s lubricating properties. • Hand-held and user friendly. • Numerical readout to facilitate trending. • Can store calibration (good oil) in its memory. • Shows changes in oil condition affected by such things as: –– Water content. –– Fuel contamination. –– Metallic content. –– Oxidation. Note The SKF Oil Check Monitor is not an analytical instrument. It is an instrument to only detect changes in the oil condition. The visual and numerical read-outs are merely a guide to enable trending of the comparative readings of a good oil to a used oil of the same type and brand. Do not rely sole

Technical data Designation mineral and synthetic oils green/red grading + numerical value (–999 to +999) Battery lifetime Dimensions instrument Carrying case dimensions (l ™ w ™ h) ® SKF is a registered trademark of the SKF Group. © SKF Group 2014 The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising...