SKF Blind housing pullers

Selection chart - SKF Blind pullers Designation Bearing bore Effective arm diameter (d) length TMMD 100 10-100 mm 135-170 mm The SKF Deep Groove Ball Bearing Puller Kit TMMD 100 allows quick and easy dismounting of SKF Deep Groove Ball Bearings with an interference fit on both rings. The SKF Blind Housing Puller Kit TMBP 20E is an adapter type puller for dismounting deep groove ball bearings in blind housings with shaft dimensions between 30 mm and 160 mm (1.18-6.3 in.). The use of extension rods allows a long reach of up to 547 mm (21.5 in.). Removes bearing without dismantling...

Easy dismounting of bearings in blind housings The puller is suitable for use in both blind housings and shaft applications. The SKF TMMD 100 is suitable for dismounting up to 71 different SKF deep groove ball bearings, with shaft diameters ranging between 10 and 100 mm (0.4-3.9 in.). • The claws are designed to precisely fit in the bearing's raceway, providing a good grip, thereby allowing high dismounting forces • Each puller arm is fitted with a spring for easy installation • The claw has been designed to allow easy insertion • The hexagon head of the spindle is designed to prevent the spanner sliding...

Technical data – SKF Blind Housing Puller Kit Designation 6 adapters sizes (2 pcs each) 2 main rods (with nut support rings and nuts) 4 extension rods Spindle Spindle nose piece Beam Maximum pulling force Technical data – SKF Deep Groove Ball Bearing Puller Kit Designation 3 ™ puller arm A1–135 mm (5.3 in.) 3 ™ puller arm A2–135 mm (5.3 in.) 3 ™ puller arm A3–137 mm (5.4 in.) 3 ™ puller arm A4–162 mm (6.4 in.) 3 ™ puller arm A5–167 mm (6.6 in.) 3 ™ puller arm A6–170 mm (6.7 in.) 2 ™ spindle and nut 1 ™ handle ® SKF is a registered trademark of the SKF Group. © SKF Group 2014 The contents of this...