TIH 220m Large induction heater with a 300 kg bearing heating capacity The large induction heater TIH 220m is a reliable and robust induction heater from the TIH...m range suitable for heating bearings up to a maximum weight of 300 kg (660 lb) and solid components up to a maximum weight of 150 kg (330 lb). Advanced design of the power electronics including current and overheating control, combined with user friendly features such as sliding arms and remote control are standard to the TIH...m range. • Capable of heating a 220 kg (480 lb) bearing in just 20 minutes • Supplied standard with two yokes, allowing bearings with a bore diameter from 60 mm (2.3 in.) up to a maximum weight of 300 kg (660 lb) to be heated • Sliding arm for large size yoke Features and benefits I nduction coil located outside the heater’s housing enables a shorter heating time and lower energy consumption Foldable bearing support arms allow larger diameter bearings to be heated, and reduce the risk of the bearing toppling during heating M agnetic temperature probe, combined with a temperature mode pre-set at 110 °C (230 °F), helps prevent bearing overheating U nique SKF remote control, with operating display and control panel, makes the heater easy and safe to use I nternal yoke storage, for smaller yoke(s), reduces the risk of yoke damage or loss I ntegrated carrying handles allow for easy movement of the heater in the workshop S liding or swivel arm allows for easy and quick bearing replacement, reducing operator fatigue (not for TI

Technical data Designation Max. bearing weight Bore diameter range Operating area (w x h) Coil diameter Standard yokes (included) to suit bearing/workpiece minimum bore diameter Application example (bearing, weight, temperature, time) Max. power consumption Voltage l) 100-240 V/50-60 Hz 100-120 V/50-60 Hz 200-240 V/50-60 Hz 400-460 V/50-60 Hz Temperature control 2) Demagnetisation according to SKF norms Dimensions (w x d x h) Total weight (incl. yokes) The comprehensive range of SKF induction heaters is suitable for most bearing heating applications. The chart gives general information on choosing...