Siviko Automated Cable Tester ACT 15 As a concept and a device SIVIKO ACT 15 is similar to the more powerful SIVIKO ACT 150, but it allows full automation of the entire measurement by internal switching of the test leads. It is very suitable for cables with fewer wires, such as installation and power cables. Highlights Ease of use: The operator just connects the test leads to the test object by matching the color coding of both, selects the type of the cable and fills-in the length of the cable. The Siviko ACT 15 does all the rest: switching between the wires, collecting measured data, monitoring safety conditions and preparing test reports. The bilingual test reports are automatically generated and are available in .pdf and .csv file formats, locally and remote. Scope: Siviko ACT 15 performs tests of conductors with active resistance up to 20 kΩ, test voltage up to 4 kV and maximum current of 4 A. The cables could have a maximum length of up to 15 km, with cross section from 0,1 to 50 mm2. It has 10 measurement leads with 5 red and 5 black crocodile clips. The maximum measurement time is 15 min 59 sec. It could run electrical tests meeting the requirements of various standards, such as EN 50525, DIN VDE 0276-603, DIN VDE 0295 / IEC 60228, BS 6004/5 etc.

General Number of wires in cable Test voltage Cable length Cable active resistance range Localization Voltage source Output Power Frequency Input voltage Input current Output voltage Output current Input protection Output protection Measurement equipment Active resistance measurement Voltage measurement Current measurement WAGO PFC200 PLC Cables with up to 5 wires with and without shield 1 ... 4 kV (for supply voltage 230/400 V) 0,1 ... 15 km 0 ... 20 kQ Short circuit and wire break * customizable * customizable * customizable * customizable 15 000 VA 50 Hz 400 V 0 . 2 A 0 ... 4000 V 0 ... 3,75...