Catalogs >
SITEMA >
Dimensions, type KRG

Dimensions, type KRG
1Pages

Catalog excerpts

o modification without prior notice f) M is the admissible load the mass to be secured exerts on the afety Lock. The holding force for dry or hydraulic-oil wetted rods is at least 2 x M. Forces exceeding 2 x M may cause damages, because the rod will be totally blocked also in the case of an overload and will not ©P-The necessary pressure to keep the clamping released is 100 bar. The admissible operating pressure is 160 bar. 0 The Safety Lock has the advantage that it does not release under load. The Safety Lock can normally be released in this case only if release pressure is applied and the load is simultaneously lifted, i.e. if the load has already been transferred safely elsewhere. To ensure this safety advantage, the load must have a minimum value during operation. This minimum value depends on the operating pressure which is applied. At 100 bar, the minimum value is F100. If the load in the application is less than F100 (at 100 bar), the clamping can be released by only applying pressure and not lifting the load. For other pressure levels, please contact SITEMA. Q On delivery, port LL is closed off by a plug screw. It may be used alternatively to port L and is useful for filling / air-bleeding the pressure chamber. As a general recommendation is to connect an auto-bleeder at the free port (see “Technical Information TI-Z10”). SITEMA GmbH & Co. KG . G.-Braun-StraUe 13 . D-76187 Karlsruhe . © Hydraulic operating volume. Q Proximity switch holders are provided for standard inductive proximity switches (M12 x 1, nominal switching distance of 2 mm, flush mountable, NO (normally open). Exception: KRG 22: M8 x 1 nominal switching distance of 1.5 mm). The dimension T2 indicates how deep the proximity switch immerses in the Safety Locks KRG measured from the holder's top. For easier service, the proximity switch holders have a depth stop and are pre-adjusted when delivered from the factory. The switches only need to be inserted to the stop and then clamped. The proximity switches are not included in the standard scope of delivery but are available as accessories. Q Internal volume changes during switching are compensated at port T. It is plugged with an air filter which, in a dry and clean factory environment, offers sufficient protection against dust etc. If, however, moisture or aggressive media are present, a pressureless hose instead of the filter must be installed to connect the Safety Lock with clean atmosphere (e.g. a clean pressureless container). © The surface of the housing parts is primed black, the front sides are treated with corrosion protection wax.

Open the catalog to page 1

Dimensions, type KRG 1Pages

Catalog excerpts

All SITEMA catalogs and technical brochures

Dimensions, type KRG
1Pages