Technical data sheet: High linearity probe LM

1 / 1 PageView full catalog

Technical data sheet: High linearity probe LM

Product catalog summary

Technical Specifications

System Parameters: The document outlines two models, LM 20 and LM 50, with measuring ranges of 20 mm and 50 mm respectively. Both models offer a resolution of 0.1 nm and maintain linearity over the entire measurement range within ≤ ±2 nm.
Clamping Shaft Diameter: Ø 8 mm h6.
Measuring Force: Fixed at the factory between 0.5 N and 1.5 N.
Operating Temperature Range: 15°C to 30°C.

Geometric Data

Dimensions: The probe without plunger measures [60 x 36 x 137] mm for LM 20 and [60 x 36 x 170] mm for LM 50. With plunger, the dimensions are [60 x 36 x 170] mm and [60 x 36 x 220] mm respectively. The electronic supply and evaluation unit measures [450 x 400 x 150] mm.
Mass: The probe weighs 370 g for LM 20 and 420 g for LM 50. The electronic supply and evaluation unit weighs approximately 8 kg.

Electrical Data

Interfaces: Standard RS232C and USB.
Cable Length: Between sensor head and electronics unit is 3 m, with an optional extension up to 10 m.
Power Supply: 100...240 VAC / 47...63 Hz.
Laser Safety Class: Complies with EN 60825-1:2014 and ANSI Z136.1 (CDRH) standards, classified as Class 1.

Additional Notes

Installation position must be observed.
Specifications are subject to change as of 11/2022.

Catalog excerpts

Technical data sheet: High linearity probe LM-1

Technical data sheet High linearity probe LM System parameter Measuring range Linearity over the entire measurement range Clamping shaft diameter Measuring force, fixed at factory * Operating temperature range Geometric Data Dimensions (L x W x H): Probe without plunger Probe with plunger Electronic supply and evaluation unit Mass: Probe Electronic supply and evaluation unit (standard) Electrical Data Interfaces Cable length between sensor head and electronics unit Power supply Laser safety class according to EN 608251:2014 and ANSI Z136.1 (CDRH) *Observe installation position SIOS Meßtechnik GmbH 98693 Ilmenau / Germany · Am Vogelherd 46 · Tel.: +49 (0) 3677 64 47-0 · [email protected] · www.sios-prec

Open the catalog to page 1

All SIOS Meßtechnik GmbH catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list