PA12 Industrial Material’s Technical Data Sheet A high resistance nylon 12 with very good dimensional accuracy of prints. Perfect for functional prototyping, jigs and fixtures and end use parts. Compatible with: very good dimensional accuracy biocompatibile1 excellent mechanical properties high chemical resistance final parts functional prototypes jigs and fixtures parts with very good dimensioning General information Material type Test method Nylon 12 Sinterit Studio Basic Software Nitrogen needed Refresh ratio Mean particle size D50 Bulk density Printout density Printout water absorption Tested for non irritant, non cytotoxicity and not a sensitizer. When producing the 3D prints, it is the manufacturer’s responsibility to confirm the specifications for the final use. Refresh ratio is the amount of refreshing powder that is required to be mixed after the printing with unsintered material. Cubic test samples with sides of 3 cm. Information provided within this document are average values for reference and comparison only. All tests were performed with print samples from Lisa X printers. Parameters presented in this specification are subject to change without notice. Final part properties may vary based on printed part design, print orientation and material handling.

Mechanical properties Test method Tensile Strength Tensile Modulus Flexural Strength Flexural Modulus Shore hardness in type D scale Impact strength (Charpy method - unnotched) Thermal properties PN-EN ISO 179- 1/1eU:2010 Test method Melting point Biocompatibility Information4 Test method Surface roughness5 Print orientation Tests were carried out in accordance with ISO 10993-1:2018. When producing the 3D prints, it is the manufacturer’s responsibility to confirm the specifications for the final use. Material properties may vary based on the design and manufacturing practices. Roughness of test...