Catalog excerpts
Falcon F35 & F45 Digital Panel Meters • 3-1/2 or 4-1/2 digit bright red LED display • Front panel pops off for easy decimal point setting and display scaling • Only 3.12" (79mm) required behind panel • Optional excitation output • NEMA 4X enclosure optional, using part # 45003 Mounting Requirements_ The Falcon series 1/8 DIN indicators require a panel cutout of 1.77" (45mm) high by 3.62" (92mm) wide. To install the Falcon into a panel cutout, remove the clips from the side of the meter. Slide the meter through your panel cutout, then slide the mount- ing clips back on the meter. Press evenly to ensure a proper fit. Tighten screws. Decimal Point Overrange indication POWER REQUIREMENTS Power Consumption Operating Temperature Storage Temperature Relative Humidity Warm-up Time NOISE REJECTION Panel Cutout Case Material Temperature Coefficient internally or on the terminal block most significant digit = "1"; other digits Automatic, with "-" indication, Less than 15 minutes Dual slope integration F35=3 samples per second, nominal; F45=2.5 samples per second, nominal
Open the catalog to page 1Falcon F35 & F45 Digital Panel Meters Specifications for F35 Frequency Meters Overrange indication POWER REQUIREMENTS Power Consumption INPUT LEVEL Operating Temperature Storage Temperature Relative Humidity Temperature Coefficient Warm-up Time Most significant digit = "1"; other digits ance OR 5V to 24V Square Wave (DC Less than 15 minutes 3 samples per second, nominal Specifications for F45 Temperature Meters Decimal Point Overrange indication POWER REQUIREMENTS Power Consumption Operating Temperature Storage Temperature Relative Humidity Warm-up Time Input Impedance Conversion Rate Open...
Open the catalog to page 2Falcon F35 & F45 Digital Panel Meters Ordering Information Falcon Indicators can be configured by making an entry in each section. Example: F35-1 -52-0. Basic Unit Power Supply Display Scaling (temp, units only) Function/Range cont'd Excitation Output (not available with AC, temperature, or frequency inputs) Display Scaling (Temperature units only) t Not available for use with frequency meters * Only available with F35
Open the catalog to page 3All Simpson catalogs and technical brochures
-
Wide-Vue
10 Pages
-
S660 Totalizer/Counter
5 Pages
-
Amik 200
8 Pages
-
Amik 100
6 Pages
-
Test Equipment Catalog
29 Pages
-
GIMA Series
2 Pages
-
2800 Series
2 Pages
-
MiniMax M240
2 Pages
-
mini-max M235 - M245
3 Pages
-
Mini M135 & M145
2 Pages
Archived catalogs
-
Test Equipment Catalog
29 Pages
-
SE Encoders
1 Pages
-
GIMA Digital Panel Meters
3 Pages
-
Panel Instrument Catalog
68 Pages