FORMING PRESSES Overview • Type: Forming presses • Press capacity: 6,000-30,000 kN • Part size: medium to large • Drive concept: eccentric (DTE), scotch yoke (DTL) • Application: cutting, blanking, forming, embossing, drawing Description The eccentric drive of the DTE series is primarily suited for flat and semi-flat parts due to its sinusodial slide motion curve. The modified slide kinematics of the DTL series is ideal for parts with a higher drawing depth. Features and Benefits • Proven and continuously optimized technology for reliable production processes • The eccentric drive of the DTE series is ideally suited for cutting, punching, bending and stamping operations • The scotch yoke drive of the DTL series reduces the slide velocity during the forming phase and thus is the perfect solution for parts with a higher drawing depth • Flexible installation options as a single press in progressive or transfer mode or as fully automated press line • The solid, low-stress annealed press bodies are FEM-cal-culated and optimized by so-called "hot-spot analysis” in areas which are subject to higher loads • Presses in tie-rod design are connected to a rigid frame by hydraulically pre-stressed tie-rods • The outside located pressure points and an 8-fold slide guiding system absorb off-center loads, spare press and die and ensure a constant part quality • The automatic centralized lubrication system increases productivity and availability Standard equipment • Moving bolster with mobile control panel • Electrical lifting gate with safety glass windows • Electrical slide adjustment, mechanical slide locking, pneumatic slide counterbalance • Air-cooled, frequency-controlled AC motor • Hydraulic unit and lubrication unit with progressive distributor • Hydraulic overload protection • Press force monitoring (single and sum force) • Vibration isolation with spring dampers • VPN interface for remote maintenance Options • Additional moving bolster in front-to-back or t-track arrangement • Press force monitoring (signature curve) • Different press enclosure concepts for noise reduction • Automatic scrap flaps • Hydraulic die clamps wi

Slide stroke down, adjustment up (SDAU) | 2P = 2-point design, 4P = 4-point design | Subject to technical modifications