Catalogs >
SIMEX Sp. z o.o. >
ProSens line accessories brochure

ProSens line accessories brochure
3Pages

Catalog excerpts

ProSens line accessories CABLE PROBES Ordering: PPQ-612-00-X-X measurement of: 2 : temperature 3 : temperature & humidity PPQ-612-00-X-X Cable probe Ø18, L=90 mm, w/o cable, housing SS 316L, filter FPQ-P350 connector type: 2 : connector, operating temp. -30 ÷ +80°C 4 : connector, operating temp. -30 ÷ +120°C PPQ-612-XX-X-X Cable probe Ø18, L=90 mm, housing SS 316L, filter FPQ-P350 Ordering: PPQ-612-XX-X-X PPQ-621-XX-X-X PPQ-622-XX-X-X measurement of: 2 : temperature 3 : temperature & humidity connector & cable type: 1 : gland, PUR covered, operating temp. -30 ÷ +80°C 3 : gland, TPE covered, operating temp. -30 ÷ +120°C Cable probe Ø12, L=200 mm, housing SS 316L, filter from SS mesh 25 µm PPQ-622-XX-X-X Cable probe Ø12, L=300 mm, housing SS 316L, filter from SS mesh 25 µm FILTERS FPQ-P350 Teflon filter (PTFE) with increased resistance against splashing water, non-absorbent surface, does not rust, operating temperature -30 ÷ +120°C Flat circular flange for Ø12 probes, SS 316L Thread bracket for Ø12 probes, SS 316L, M20x1,5 Wall mounting bracket for Ø12 and Ø18 probes, SS 316L Thread bracket for Ø18 probes, M25x1,5 SIMEX Ltd., Wielopole 11, 80-556 Gdańsk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.sime

Open the catalog to page 1

ProSens line accessories CONNECTION ACCESSORIESE M12 connector, 4-pin, w/o cable for PPQ-612 probes, operating temp. -30 ÷ +80°C M12 connector, 4-pin, cable 3 m, for PPQ-612 probes Ordering: CPX-30 operating temp.: Q : standard: -30 ÷ +80°C, cable TPU covered T : expanded: -30 ÷ +120°C, cable TPE covered ADDITIONAL ACCESSORIES SIR-15 InfraRed remote controllers may be used as external programming keyboard for all SIMEX devices equipped with IR receivers and remote programming functions. Pressing of any local IR controller key, causes transmission of it's code to the device. Functions of...

Open the catalog to page 2

ProSens line accessories SOFTWARE S-Config 2 is used for the simultaneous detection of devices in multiple Modbus RTU networks and allows user to change the configuration of most of them. For each detected device a list of its registers, which the user can modify, is displayed and also additional informations about device parameters (type, address in the network, etc.). S-Config software can be downloaded from SIMEX website at www.simex.pl SimCorder Soft is a visualisation application created to facilitate work with advanced networks of the SIMEX devices, for acquisition, visualisation,...

Open the catalog to page 3