Catalogs >
SIMEX Sp. z o.o. >
Process meter SRP-73 datasheet

Process meter SRP-73 datasheet
3Pages

Catalog excerpts

Process meters SRP-73 process meter in a small case 2 display types: 4 x 13 mm or 5 x 9 mm inputs: 0/4-20 mA, 0/1-5V, 0/2-10V, 0-60/75/100/150 mV 0, 1 or 2 relay (or OC) outputs power supply output: 24V DC RS-485 / Modbus RTU free configuration software S-Config The SRP-73 meter is designed for measuring of typical current or voltage signals. Easy programming and installation, small size and high reliability are basic advantages of the SRP-73 process meters. Thanks to wide range of characteristic curves (linear, square root, quadratic, user-defined and volume characteristic for cylindrical tanks) the meters may be used in various process control systems. The 24V DC / 100 mA output is designed to supply measuring transducers, and the RS-485 port enables data transmission in production process monitoring systems. The REL / OC control outputs can adjust the level of measured signal and are controlled according to one or two threshold values. The meter can be configured with the local keyboard or free S-Config software via the RS-485 communication port. SIMEX Ltd., Wielopole 11, 80-556 Gdansk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.simex.pl

Open the catalog to page 1

Process meters Side view Panel cut-out dimensions EXAMPLARY PIN ASSIGNMENTS R2 (option) number of outputs: 0 1 2 type of outputs:- options: 00 : no options 01 : IP 65 frame 08 : operating temp. -20°C f +50°C 0P : operating temp. -20°C f +50°C + IP 65 frame SIMEX Ltd., Wielopole 11, 80-556 Gdansk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.simex.pl

Open the catalog to page 2

Meters accessories MOUNTING PLATES SMP-147/73 to mount 72 x 36 mm size unit in place of 144 x 72 mm cut-out BOARD THICKNESS BRACKETS / ADAPTORS SPH-07 1 ÷ 7 mm board thickness brackets (2 pcs) standard included with device SPH-05 1 ÷ 5 mm board thickness brackets (2 pcs) SPH-45 1 ÷ 45 mm board thickness brackets (2 pcs) SOFTWARE S-Config 2 is used for the simultaneous detection of devices in multiple Modbus RTU networks and allows user to change the configuration of most of them. For each detected device a list of its registers, which the user can modify, is displayed and also additional...

Open the catalog to page 3