Process meters Qsimex SRP-147 process meter with a large 4 x 38 mm display inputs: 0/4-20 mA, 0/1-5V, 0/2-10V, 0-60/75/100/150 mV 0, 2 or 4 REL / OC outputs analogue output: active or passive, power supply output: 24V DC RS-485 / Modbus RTU signal peak value detection free configuration software S-Config The SRP-147 meter is designed for measuring of typical current or voltage signals. As a main advantage, this device is equipped with a large, 38 mm high LED display. Thanks to wide range of characteristic curves (linear, square root, quadratic, user-defined and volume characteristic for cylindrical tanks) the meters may be used in various process control systems. The 24V DC / 100 mA output is designed to supply measuring transducers, and the RS-485 port enables data transmission in production process monitoring systems. The REL / OC control outputs can adjust the level of measured signal and are controlled according to one or two threshold values. Moreover, the meter can be equipped with analogue outputs, according to the customer selection: active current output, passive isolated current output or active voltage output. The meter can be configured with the local keyboard or free S-Config software via the RS-485 communication port. SIMEX Ltd., Wielopole 11, 80-556 Gdansk, Poland, tel. (+48) 58 762-07-77, fax 58 762-07-70, www.simex.pl

Process meters DIMENSIONS 92 mm Side view Case dimensions Panel cut-out dimensions 9 10 ACTIVE voltage output version with 2 x REL and 1 x AO 0/1-5V, 0/2-10V, active PASSIVE isolated current output version with 2 x OC and 1 x AO 4-20 mA, passive version with 2 x REL and 1 x AO 0/4-20 mA, active 85-260V AC/DC 6,5W ACTIVE current output ORDERING SRP-147-1XXX-1-X-XX1 type of input: 8 : 0-20 mA, 4-20 mA, 0/1-5V, 0/2-10V C : 0-60/75/100/150 mV number of outputs: 0 2 3 4 options: 00 : no options 01 : IP 67 frame 03 : green colour LED display 04 : IP 67 frame + green colour LED display 08 : operating...

Meters accessories BOARD THICKNESS BRACKETS / ADAPTORS SPH-07 1 ÷ 7 mm board thickness brackets (2 pcs) standard included with device SPH-05 1 ÷ 5 mm board thickness brackets (2 pcs) SPH-45 1 ÷ 45 mm board thickness brackets (2 pcs) SOFTWARE S-Config 2 is used for the simultaneous detection of devices in multiple Modbus RTU networks and allows user to change the configuration of most of them. For each detected device a list of its registers, which the user can modify, is displayed and also additional informations about device parameters (type, address in the network, etc.). S-Config software...