The simatool Fitting Tool FT-P, in combination with a mechanical press, guarantees the correct assembly of components with an inside diameter of greater than 50 mm. The FT-P is the ideal solution for installations with high installation forces. • High-quality case with attached instructions simatool Fitting Tool FT-P Technical data sheet - simatool Fitting Tool FT-P

Technical data sheet simatool Fitting Tool FT-P max. The tool can be used on presses up to a maximum press-in force of 5 tonnes. If there is a suitable receptacle, the sleeve can also be screwed tightly to the press. Can be used with the rings C35 / 62 to C50 / 110 of the FT 33 Thanks to the special DC adapter of the FT-P, the C-rings of the Fitting Tool FT 33 can also be used on presses. Seals can be mounted without a press Seals with an inside diameter of up to 60 mm can be easily mounted using a hammer. On roller bearings with bore diameter 55, on the other hand, the tool must be used with...